AR-B1656 Manual

Version 1.1

1.  SETTING UP THE SYSTEM

TOP PLACEMENT

BOTTOM PLACEMENT

1.1 Keyboard & Mouse Connector (KB1)

1.2 SO-DIMM DDR-SDRAM SOCKET 200 PIN (DIMM1)

200 pin SO-DIMM

1.3 Hard Disk (IDE) Connector (IDE1&Ide2)

1.4 USB Connector (USB1)

n  USB1

1.5 Serial Port (COM1, COM2,CN5)

1.6 FAn Power Connector (CN6)

1.7 Internal Buzzer (U7)

1.8 Ethernet rj-45 (LAN1, LAN2, LAN3)

1.9 Ethernet led (led2, LED3, LED4)

○

1.10 Reset Button (CN11)

1.11 Power Button (CN3)

1.12 Power JACK (CN9)

1.13 Mini PCI Slot (PCI2)

On board one mini PCI slot (PCI2)

1.14 pci Slot (PCI1)

On board one PCI slot (PCI1)

1.15 power/hd/watchdog led (led1)

1.16 isp cpld CONNECTOR(cn7)

VV

1.17 SYSTEM MANAGEMENT BUS (CN8)

1.18 GPIO Port (CN4)

1.19 BYPASS SETTING JUMPER (J1) à OPTION

1.20 Compact Flash Slot (CF1)

1.21 COM2 SETTING JUMPER (JRS2)

1.22 CMOS Reset (CN14)

Page 1 of 8 AR-B1656 Manual Part No: 220010142

START UP SETTING

Power Button Setting

You can only choose 1 between 2 option, Mechanical Power Button and Trigger Power Button to power AR-B1656. Default is Mechanical Power Button.

·  Place power button cable on CN2 if you use Mechanical Power Button. Wait for 4-6 second after you turn off the power

·  Place power button cable on CN3 if you use Trigger Power Button. To turn off the system hold button for 4-6 second.

ByPass Setting à OPTION

To protect the initial port from bypassing, place the cap on the location 2-3 of J1

J1 : ByPass setting

J1 / DESCRIPTION
2-3 / Normal
1-2 / Bypass


WATCHDOG TESTING


GPIO TESTING

GPIO can only be set as all input or all output.


PROGRAM MAC ADDRESS

Program the eeprom in engineering mode

(1) Boot from DOS (Win 98 preferred) and type b44diag –b44eng

(2) 0:>sromutil –m 001018000001 14e4 8401. MAC address 001018000001, SVID:14e4 and SID:8401 will be programmed into eeprom. You can change to other values if nevessary.

(3) 0:>sromutil –b 0. Disable PXE function on NIC if PXE binary image is being integrated into BIOS.

(4) 0:>sromutil –d –feeprom.bin, you will get your golden eeprom.bin file

(5) Exit to DOS

(6) Re-boot the system

(7) Under engineering mode, customers can see a list of all commands by typing “help” after 0:>. In addition, for all parameters, please type 0:>command ? (for example 0:>secfg ?, and you should get a list of all parameters associated with that specific command),

BYPASS TESTING à OPTION

Our board has a jumper to initialize state, bypass or normal on J1. Connected J1.1 to J1.2 means initialize state is bypass, and connected J1.2 to J1.3 means initialize state is normal.

Page 1 of 8 AR-B1656 Manual Part No: 220010142