BV Lab Number:
Technician Name:

MOTHERS WORK TEST PROTOCOL FOR

MW-7079-US /
Body / Foot / Face / Hand Scrub /
Evaluation / Citation/Method / No. Samples / Criteria / Results / Rating /

SUPPLEMENTAL PROTOCOLS

* CA Prop 65
Upon Request / Applicable Section from Protocol
MC-6572-US / - / The sample shall be reviewed against the requirements of California Proposition 65 to determine if additional testing or labeling is required.
Note: Additional cost, sample size & TAT may be required if testing to one or more supplemental protocol is necessary.
Please refer to the above referenced supplemental protocol(s) for additional information.

LABELING

One Time Use Products
**Fair Packaging and Labeling Act OR All Other Products
**Uniform Packaging and Labeling Regulations / F.P. & L. Act
(16 CFR 500)
OR
NIST Uniform Laws and Regulations Handbook 130 / 1 / Manufacturer, Packer, or Distributor’s Name & Address (City, State & ZIP Code) /
Product Identification
Net quantity of contents shall be expressed in terms of weight or mass, measure, numerical count, or combination so as to give accurate information to facilitate consumer comparison (U.S. and metric units).
**Country of Origin Marking / 19 CFR 134 / 1 / Shall indicate country of origin legibly, permanently, and in comparable size and close proximity to any mention of country other than country in which the article was manufactured or produced. Must be visible at point of purchase.
Claim verification (Level 2) / CPSD-HL-08612-MTHD / All / Examine the retail packaging (or submitted artwork).
Record each objective (factual) claim which can be substantiated by the testing within this protocol and rate accordingly.
Any net quantity/dimensional claims evaluated in other sections of this protocol need not be recorded.
Record all other objective (factual) and subjective (opinion) claims as ‘NT’ for Not Tested and rate as ‘FAIL’.
*Cosmetic Ingredients List - Review for color additives and inhibited substances and colorants / 21 CFR 701-2004 & 740-2004 Cosmetic Labeling and 21 CFR 700-2004 et al and 73, 74 & 82 / 1 / Must contain an ingredients listing including colorant additives.
May not contain any inhibited substances or colorants.
*Cosmetic Labeling Review / 21 CFR 701-2004 & 740-2004 Cosmetic Labeling and 21 CFR 700-2004 et al and 73, 74 & 82 / 1 / Shall conform to the labeling requirements of Title 21, Section 701 and 740
Usage Directions / CPSD-HL-01057-MTHD / 1 / Shall be clear and understandable and provided in language appropriate to destination countries as applicable.
Warning Label / CPSD-HL-01057-MTHD / 1 / Shall be clear and understandable and provided in language appropriate to destination countries as applicable.

ANALYTICAL

* Lead In Surface Coating / ASTM E1613-04 / E1645-01
(Mod.) / 1 / Shall not exceed 600 ppm (0.06% by weight) total lead.

PHYSICAL CHARACTERISTICS

Net Contents / CPSD-HL-01057-MTHD / 1 / Report actual. Must meet or exceed label claim. / C:
R:
Appearance / CPSD-HL-01057-MTHD / 1 / Report actual.
Fragrance / Organoleptic / 1 / Report actual. Shall not have any off or objectionable odors.
Thickness/Feel / Organoleptic / 1 / Report actual.
Viscosity, cps / ASTM D2196-05 / 100 g / Report actual.
Percent Solids / 3 g, 105oC, 3 hours / 3 g / Report actual.
Thermal Stability / 3, 24 hour cycles
0oF and 115oF / 50 g / Shall have no change in color, fragrance or consistency and have no visual separation.
pH / Std. Measure / 10 g / Report actual.

MICROBIOLOGICAL

*Cosmetics, Liquids, Pastes, Putties, Gels and Powders – USP 61 / CTFA and USP <61> / 50g / Cosmetics shall meet the requirements of 5,000 CFU/ml ( 500 CFU/ml for cosmetics intended for use with the eyes and lips) as intended to minimize risk associated with lack of cleanliness, shelf life and contamination (Documentation may be submitted if dated within 1 year).
*Cosmetics, Liquids, Pastes, Putties, Gels and Powders – USP 51 / CTFA and USP <51> / 150g / Documentation dated within 1 year must be submitted for substantiation of the cosmetics complying with the preservative efficacy requirements from CTFA or USP <51> (Documentation my be submitted if dated within 2 years).

CONSTRUCTION & WORKMANSHIP

Defects / CPSD-HL-01057-MTHD / All / Shall have no discernible surface degradation, including crazing, shivering, denting, bubbles, cracks, stains, deformations, chips, fractures, heavy lines, waves, shear marks, scratches, scuff marks, indentations, or blisters.
Workmanship / CPSD-HL-01057-MTHD / All / Shall have no components missing, malformed, and/or fractured.
Dispenser Function / CPSD-HL-01058-MTHD / All / Shall function as intended as received. Report details of evaluation (features tested / methods used / materials used / etc.) Report any features not evaluated.

Key:

* / Additional Charge For This Test / ** / Mandatory Requirement

Results Key:

M / Meets / NM / Does Not Meet
NA / Not Applicable / NT / Not Tested
C / Claimed / R / Recorded
No. Of Samples Required For Complete Testing: / 3 / Minimum 32oz. / Client Approval:
No. Of (Fully Packed) Cartons For Transit Testing: / 1 / Creation Date: / September 6, 2007
No. Of Working Days For Complete Testing: / 10 / Editorial Revision Date:
Pricing Review Date:
Technical Review Date:
Pricing Information (US$) / USA / Europe / Overseas
Basic Test Package Price: / $ / 385.00 / $ / 310.00
*Additional Charges:
Lead in Surface Coating / $ / 79.00 / $ / 33.00
Cosmetic Label Review / $ / 165.00 / $ / 133.00
Cosmetic Ingredient Review / $ / Included in above pricing / $ / 67.00
USP 51 / $ / 500.00 / $ / 867.00
USP 61 / $ / 300.00 / $ / 240.00
CA Prop 65 / MC-6572-US / MC-6572-US

Revision History:

1) 9/6/07 – Created protocol per Cora Gauthier’s request by BV-HK-KC-Kit with reference SK-7079-US

Page 2 of 3