PROGAMMING ZENITH Decoder for NGC

PROGAMMING ZENITH Decoder FOR NGC

1: ADVANCED SETUP
A. Press Mosaic
B. Press up/down button and highlight advance setup, then press" O".
C. Enter 0000, then press "O".
D. Highlight LNB SETUP then press "O".
E. Highlight NONE then press "O".
F. Highlight MECHANICAL then press "O".
G. Highlight 5150 MHz C- Band, and then press "O".
H. Highlight YES TO CONTINUE then press "O".
I. Press GO BACK and highlight SELECT YOUR SATELLITE.
2: SELECT YOUR SATELLITE
A. Press down button and highlight SELECT SATELLITE, then press "O".
B. Enter 000, then press "O"
C. Press up/down arrow to highlight SATELLITE D, then press "O"
D. Press + button on the remote control.
E. Enter frequency 03880, then press "O".
F. Press down/up arrow and highlight HORIZONTAL, then press "O".
G. Enter SYMBOL RATE 26.850, then press "O".
H. Press down /up arrow and highlight 7/8, then press "O".
I. Press down/up arrow and highlight QPSK, then press "O".
J. Press down/up arrow and highlight AS-3S 7H, then press "O".
K. NOTE: the SIGNAL STRENGHT & THE SIGNAL QUALITY (BER is 1.3E-6 in POM).
NOTE: If data is still down loading and you press 724 the picture will not come on instead it goes back to the same page.
3: HOW TO CHECK SCHEDULE
A. Press MOSAIC then press right button 2 times.
B. Highlight SCHEDULE, and then press "O".
C. If down loading is still in progress, wait until down loading is completed.
D. Enter figure 274 to view the picture.
SETUP FAVOURITE CHANNEL
A: Press MOSAIC.
B: Press right button 3 times and highlight FAVOURITE CHANNEL, then press "O".
C: Press down /up button and highlight 900 then press "O".
D: Press down /up button and highlight NATIONAL GEOGRAPHY then press "O".
E: Unplug the decoder and power it again after 20 seconds and verify that the picture is back on the programmed favourite channel.