Hello Friend

All images © 1990-2017 Stampin’ Up!®

Supplies:

·  Stamp Sets: Hello Friend (144059-c; 144055-w), Pieces & Patterns (143843)

·  Card stock & paper: Sahara Sand (121043), Crushed Curry (131199), Whisper White (100730), Pick a Pattern Designer Series Paper (144163)

·  Stampin’ Pad: Sahara Sand (126976), Crushed Curry (131173) and Emerald Envy (141396)

·  Miscellaneous: 5/8” Burlap Ribbon (141487), Classic Label Punch (141491), Stitched Shapes Framelits (145372), Layering Ovals Framelits (141706), Big Shot Die-Cutting Machine (143263), Magnetic Platform (130658), SNAIL Adhesive (104332), Stampin’ Dimensionals (104430), Mini Stampin’ Dimensionals (144108), Paper Snips (103579), and household stapler

Measurements:

·  Sahara Sand card stock: 4-1/4” x 11”, scored at 5-1/2 then folded to create card base plus 4” x 3” plus scrap for sentiment

·  Crushed Curry: 4” x 5-1/4”

·  Designer Series Paper: 3-3/4” x 5”

·  Whisper White: 3-3/4” x 3”

·  Burlap Ribbon: about 5-1/2”-6”

Instructions:

·  Using SNAIL adhere Designer Series Paper piece to Crushed Curry then to card front

·  Stamp “hello” with Crushed Curry on Whisper White. Position sentiment so it’s towards the top of the scrap then, using a stitched oval die, die-cut it out

·  Stamp flower from Pieces & Patterns using Sahara Sand onto left side of area below the “he” of “hello”

·  Die cut larger oval from Layering Ovals Framelits and layer beneath the white stitched oval with the “hello” on it

·  Fold Burlap Ribbon in half, trim at an angle with Paper Snips, spread points out, align behind the Sahara Sand/Whisper White piece and staple to edge so it peeks out a little over 1”

·  Stamp “FRIEND” in Emerald Envy on Sahara Sand scrap then punch out with Classic Label Punch aligning the punch so it’s only about ¼” from the right edge of the word. Once punched, using Paper Snips, trim off left point centering the word on the scrap as you trim

·  Using Mini Stampin’ Dimensionals, adhere “FRIEND” piece to “hello” piece so it slightly overlaps the flower.

·  Using regular Stampin’ Dimensionals, adhere entire focal piece to card front.