MATERIAL SAFETY DATA SHEET 1/3

______

1. CHEMICAL PRODUCT & COMPANY IDENTIFICATION

CHEMICAL PRODUCT NAME : FC - 100

NAME OF MANUFACTURER : ENERCHEM (S) PTE.LTD.

NAME OF SECTION : PRODUCTION DEPARTMENT

ADDRESS : 48 WOODLANDS IND PARK E7

SINGAPORE 757822

TELEPHONE : 62579923

FASCIMILE : 62579077

2. MATERIAL IDENTIFICATION

CLASSIFICATION OF SINGULAR PRODUCT/MIXTURE :

Singular Components: HOMOPOLYMER OF PHOSPHINOCARBOXYLIC ACID

COMPOSITION COMMENTS

Aqueous solution of phosphinocarboxylic acid

______

3.HAZARDS, TOXICITY IDENTIFICATION

Not regarded as a health or environmental hazard under current legislation.

______

4.FIRST-AID MEASURE

INHALATION

Provide fresh air, warmth and rest, preferably in a comfortable upright sitting position.

Get medical attention if any discomfort continues.

INGESTION

DO NOT INDUCE VOMITING!

Rinse mouth thoroughly.

Get medical attention.

SKIN CONTACT

Immediately remove contaminated clothing.

Rinse immediately with plenty of water.

Continue to rinse for at least 15 minutes.

Get medical attention promptly if symptoms occur after washing.

EYE CONTACT

Rinse the eye with water immediately.

Continue to rinse for at least 15 minutes.

Contact physician if irritation persists.

5.FIRE-FIGHTING MEASURES

EXTINGUISHING MEDIA

Use: Water spray, fog or mist. Foam, carbon dioxide or dry powder.

6. ACCIDENTAL RELEASE MEASURES

SPILL CLEAN UP METHODS

Should be prevented from entering drains.

Absorb in vermiculite, dry sand or earth and place into containers.

Collect and reclaim or dispose in sealed containers in licensed waste.

Containers with collected spillage must be properly labelled with correct contents and hazard symbol.

2/3

7. PRECAUTIONS IN HANDLING AND STORAGE

USAGE PRECAUTIONS

Avoid spilling, skin and eye contact.

STORAGE PRECAUTIONS

Store separated from: Alkalies. Reducing Agents. Do NOT use container made of: Carbon steel. Keep containers tightly closed.

______

8.EXPOSURE PREVENTIVE MEASURE

INGREDIENT COMMENTS

No exposure limits noted for ingredient(s).

ENGINEERING MEASURES

No particular ventilation requirements.

RESPIRATORY EQUIPMENT

Respiratory protection not required.

HAND PROTECTION

Selection of a suitable glove depends on work conditions and whether the product is present on its own or in combination with other substances.

Gloves should be replaced immediately if signs of degradation are observed.

It has been found that gloves made from rubber, neoprene or PVC provide short-term splash protection.

EYE PROTECTION

Wear approved safety goggles.

OTHER PROTECTION

Wear appropriate clothing to prevent repeated or prolonged skin contact.

HYGIENE MEASURES

No specific hygiene procedures noted, but good personal hygiene practices are always advisable, especially when working with chemicals.

9.PHYSICAL AND CHEMICAL PROPERTIES

APPEARANCE: Liquid

COLOUR: Colourless

ODOUR: Slight odour

SOLUBILITY: Miscible in all proportions

BOILING POINT (°C) 101 - 103

RELATIVE DENSITY 1.17 - 1.20 @ 20 °c

VAPOUR PRESSURE 17.5 mmHg @ 20 °c

pH-VALUE, CONC. SOLUTION 3.5-4.5

VISCOSITY 35 - 60 cSt @ 25 °c

PARTITION COEFFICIENT

(N-Octanol/Water) <0

______

10. HAZARD INFORMATION

CONDITIONS TO AVOID

Reacts with alkalis and generates heat

11. TOXICOLOGICAL INFORMATION

TOXIC DOSE 1 - LD 50 > 5000 mg/kg (oral rat)

SKIN CONTACT

Non Irritant

Not a Skin Sensitiser

EYE CONTACT

Non irritant

3/3

12. ECOLOGICAL INFORMATION

LC 50, 96 Hrs, FISH mg/l >1000

EC 50, 48 Hrs, DAPHNIA, mg/l 320

IC 50, 72 Hrs, ALGAE, mg/l 130

DEGRADABILITY

Not readily biodegradable

WATER HAZARD CLASSIFICATION

1 Officially classified

Chemical Oxygen Demand, 370, 000

COD

13. DISPOSAL CONSIDERATION

DISPOSAL METHODS

Absorb in vermiculite or dry sand, dispose in licensed special waste.

14. PRECAUTION ON TRANSPORTATION

RAIL TRANSPORT NOTES Not Classified

SEA TRANSPORT NOTES Not Classified

AIR TRANSPORT NOTES Not Classified

Not classified for

transportation.

ADR CLASS MARINE POLLUTANT No

15. REGULATORY INFORMATION

RISK PHRASES

NC Not classified

16. OTHER INFORMATION

All inquiries regarding the contents of this MSDS shall be made to:

ENERCHEM (S) PTE LTD.

Production Department

Tel: (65)62579923

Fax: (65)62579077

To the best knowledge, the information contained here in is accurate. However, Enerchem (S) Pte. Ltd. assumes any liability whatsoever for accuracy or completeness of the information contained herein. All materials may present unknown hazards and should be used in caution. Although certain hazards are described herein, we cannot guarantee that these are the only hazards, which exist.

______