EASEC-14-Extended Abstract Template

2ndJSCE-CICHE Joint Workshop May 18 &19, 2017

Paper Title Submitted to J-C Joint WS.

DangDang Tung1, Author 22 and Author 33

1Faculty of Civil Engineering, CICHE University,Taiwan

2Affiliation for Author 2

3Affiliation for Author 3

EXTENDED ABSTRACT:

This template shows the required format for the Extended Abstract to be submitted to the 1st2nd JSCE-CICHEJoint Workshop which will be held on May 18-19, 2017 in Tokyo, Japan.The Extended Abstract will be included in the “Book of Abstracts”, which will be distributed during the conference.

The Extended Abstract should be at least 400 words, but not exceeding two A4 pages. It should include the figures and tables (if any). At the end of the Extended Abstract, the authors should provide the list of key references and at most 5 keywords for the classification of your paper in the conference.

Page margins should be 2.5 cm for top and bottom margins, and 2 cm for left and right margins. Except the paper title, all text in the abstract should be used font type Times New Roman with 12 pt font size and single line spacing (12 pt before and after paragraph). The paper title should be used font type Times New Roman with 18 pt font size and exact 24 pt line spacing (48 pt and 24 pt before and after paragraph, respectively).

The Extended Abstract should be submitted to

2nd JSCE-CICHE Joint WS management,

The figure, table, their captions must be centered in boldwith 12pt font size.

Figure 1: An example of figure style.

Table 1: An example of table style

KEYWORDS: (maximum 5 keywords)

REFERENCES

To cite sources in the text, use the author-date method; list the last names of the authors, then the year. The formats are as follows: one author—(Smith 2004); two authors—(Smith and Jones 2004); three or more authors—(Smith et al. 2004). Prepare a reference section listing all references alphabetically by last name of the first author. Below are samples of properly formatted and complete references:

Journals: King, S., and Delatte, N. J. (2004). “Collapse of 2000 Commonwealth Avenue: Punching shear case study.” J. Perf. Constr. Facil., 18(1), 54-61.

Conference Proceedings and Symposia: Fwa, T. F., Liu, S. B., Teng, K. J. (2004). “Airport pavement condition rating and maintenance-needs assessment using fuzzy logic.” Proc., Airport Pavements: Challenges and New Technologies, ASCE, Reston, Va., 29-38.

Books and Reports: Feld, J., and Carper, K. (1997). Construction failure, 2nd Ed., Wiley, New York.

CD-ROM: Liggett, J. A., and Caughey, D. A. (1998). “Fluid statics.” Fluid mechanics (CD-Rom), ASCE, Reston, Va.