BEKA PROJECTOLUX
Asymmetrical Floodlight Range
Specifications
DESIGNED FOR SPORTS FIELD, HIGH MAST, INDUSTRIAL, SECURITY, AREA, FAÇADE AND APRON FLOODLIGHTING
The luminaire shall consist of a die-cast aluminium (EN 1706 AC-44300) housing with a separate but attached gearbox designed to operate 400/600/1000W high-pressure sodium and 400/1000W metal halide tubular lamps.
The luminaire shall bear the SANS 475 performance mark and the SANS 60598-2-5 safety mark.
IP 65 in compliance with SANS 60598-2-5.
The IP rating shall be certified by an SABS test report.
PRL 400W
The lamp and control gear compartment shall be robustly constructed, weatherproof, hail proof, corrosion proof and vandal resistant. It shall be manufactured from high pressure die-cast aluminium (EN 1706 AC-44300). The gear compartment shall consist of a lid and body that seals the control gear compartment to an IP 65 ingress protection rating when closed. The control gear compartment shall be attached to the lamp housing.
PRL 600W/1000W
The lamp and control gear compartment shall be robustly constructed, weatherproof, hail proof, corrosion proof and vandal resistant. It shall be manufactured from low pressure die-cast aluminium (EN 1706 AC-44300). The gear compartment shall consist of a lid and body that seals the control gear compartment to an IP 65 ingress protection rating when closed. The control gear compartment shall be attached to the stirrup.
The front glass covering the lamp compartment shall be heat and impact resistant, held to the lamp housing by stainless steel clamps and sealed by an extruded heat resistant silicon gasket.
Helicoils shall be inserted for the attachment of the lamp housing and the gear compartment to prevent the galvanic corrosion of stainless steel screws to the aluminium housing.
The reflector system shall be manufactured from 99,98% super-pure anodized aluminium and consist of the back reflector and two side reflectors. The luminaire shall be available in an asymmetrical narrow, medium and wide beam distribution.
Lamp replacement shall be facilitated from the side by a high-pressure die-cast aluminium lampholder housing. It shall be sealed with a one-piece silicon gasket and shall be held to the floodlight with two stainless steel screws.
Aiming device shall be available on request, in order to set the floodlight to the desired aiming angle.
The lamp holder shall comply with VC 8011, shall be rated to withstand 240°C/5kV. The control gear shall be incorporated inside the control gear compartment and shall be mounted on a removable gear tray. It shall be suitable for operation with the 400/600/1000W lamp on a 230V +3%/-10% 50Hz single phase system.
All control gear components shall be removable and bear the relevant SABS mark. All screws, bolts and metal parts shall be stainless steel or anti-corrosion treated material. Mains connections shall be by means of a suitable screw terminal block with wire clamping contact.
Ignitors, where applicable, shall be of the superposed pulse type. The luminaire shall be power factor corrected to a minimum of 0,9. Tapped control gear shall be available on request.
The stirrup shall be manufactured from hot dipped galvanized steel. Holes shall be provided for mounting purposes. A stainless steel version shall be available on request.
Updated by / Approved by / Document Revision / DateNadja Smith / Daniel Kasper / 19/10/2017
3 | Page