User’s Manual
AH100 Telephone Headset
with Amplifier
Diagram
Connection
- Unplug the telephone plug from the telephone set. Plug it into the [LINE] jack on the amplifier.
- On the amplifier, there is a PHONE cable (which the size of plug is bigger), plug it into the telephone set.
- Unplug the handset cord from the telephone set, plug it into the of the amplifier.
- On the amplifier, there is a HANDSET cable (which the size of plug is smaller)
- Plug the headset into the jack.
- If there is any recording device, connect the recording cable to jack.
Setting
- Connect all cables according to the instructions above.
- Slide theswitch to
- Lift the handset to see if the POWER indicator lights on. If it does, then the switch is at its correct position. If not, slide it to the other side. The POWER indicator will light up
- Hang up the phone and lift the handset again, listen to the receiver to see if there is sound from the handset. If there is, then the switch is at correct position. If not, slide it to the other end, you will hear the sound.
!If you cannot get power indicator light on with both positions, please contact your dealer.
!With some system, the power indicator lights on either side of switch. In this case, you can leave the switch on either side.
1
Operation
Using Handset
Slideswitch to , you can use handset to talk.
Using Headset
Slide to, you can use the headset. While you talk with headset, still need to lift the
1
handset and put it aside. After the call, put it in the cradle to cut the connection.
Setting Earphone Volume
1
Adjust the control to get the most comfortable volume.
Setting Microphone Volume
Adjust the switch to change the microphone level. There are 3 positions H, M and L for microphone volume.
!The volume adjust only available for headset. It won’t affect the volume of the handset.
Recording
You can record the conversation with an external device such as digital recorder or PC sound card. Connect the audio cable to jack, no matter you use headset or handset, you can record the voice
1