Keywords Type Your Keywords Here. Try Not to Use a Long List (3-5 Is OK)

1

PAPER ID 0001

Place your title here

Abstract—Write your abstract here. Ideally it should be self-contained and understandable by the general OR reader outside the context of the article. It should be free from formulae, specialized jargon, acronyms and references. It should be specific and between 50 and 150 words of length.

Keywords—Type your keywords here. Try not to use a long list (3-5 is OK).

I.This is the header of the first section

This is the template file for the papers presented at the fourth ORP3 Meeting at Guimarães, Portugal. Please, copy it to a new file with a new name and use it as the basis for your article. The template is based on the IEEE journal papers produced under LaTeX using IEEEtran.cls version 1.6b and later, and it is derived from the template of the third ORP3 Meeting in Valencia, Spain.

Authors should follow these guidelines:

1)Manuscripts should be written in English. Authors are encouraged to obtain assistance in the editing of their papers for proper use of English prior to submission.

2)Titles, both of the article itself and of the sections, should be brief and specific.

3)Name(s) of the author(s): for information retrieval, please specify your name always in exactly the same way; initials or given name first, and family name last.

4)Full mailing address(es), including e-mail, of the author(s) should be given, at the institution where the research has been done. If the current mailing address differs, this should be supplied in a foot-note. Please indicate the corresponding author.

5)Paragraphs should be indented in the manuscript to avoid ambiguities when a line ends in a full stop.

6)Tables hardly ever need vertical lines. They should have a self-explanatory title. In designing tables please take consider the examples given below.

7)Figures should also have a self-explanatory caption. Special care should be given to the drawing. Figures can be included in a column or in multiple columns. Subfigures are also possible (see the following examplesbelow.

7)Figures should also have a self-explanatory caption. Special care should be given to the drawing. Figures can be included in a column or in multiple columns. Subfigures are also possible (see the following examples).

8)Formulae should normally be displayed on a separate line and numbered, if referred to, in parentheses on the right. Keep formulae as simple as possible. The solidus / is preferable to the horizontal division line. Avoid the letters o and l. Avoid super-or subscripted super- or subscripts.

9)References should be written preferably sorted alphabetically independently of the order in which they are cited. Citations should be of the type [1] and multiple citations should be ordered, i.e. [6], [10], [19], [30-32].

A.Subsection header

Subsection text here.

1) Subsubsection header: Subsubsection text here.

II.Figures and Tables

An example of a floating figure is shown in Figure 1.

In Figure 2 we have an example of a double column floating figure using two subfigures (Figures 2(a) and 2(b)).

Finally, wide single figures are also possible (See Figure 3).

An example of a floating small table is shown in Table I. Note that the caption should come BEFORE the table.

Fig. 2 Two logos side by side

Fig. 3. Solution of a 2D Bin-Packing Problem

Fig. 1. UM logo

TABLE I

Asimple table example

1 / 2 / 3
4 / 5 / 6

Wide tables can also be typed (see Table II for an example).

III.Equations

In-line equations are preferred whenever possible: i, i = 3, …, n. For bigger expressions use a lined equation (see equation (1)):

(1)

IV.Conclusions

The conclusions go here.

Appendix

Appendix text goes here.

Acknowledgements

The authors would like to thank…

References

[1]J. B. Anderson and K. Tepe, “Properties of the tailbiting BCJR decoder,” in Codes, Systems and Graphical Models, ser. IMA Volumes in Mathematics and Its Applications. New York: Springer-Verlag, 2000.

[2]J. Breckling, Ed., The Analysis of Directional Time Series: Applications to Wind Speed and Direction, ser. Lecture Notes in Statistics. Berlin, Germany: Springer, 1989, vol. 61.

[3]B. K. Bul, Theory Principles and Design of Magnetic Circuits.Moscow: Energia Press, 1964, p. 464, (in Russian).

[4]J. C. Candy and G. C. Temes, Eds., Oversampling Delta-SigmaData Converters Theory, Design and Simulation. New York:IEEE Press., 1992.

[5]M. Coates, A. Hero, R. Nowak, and B. Yu, “Internet tomography,”IEEE Journal of Selected Areas in Communication, May2002, to be published.

[6]B. D. Cullity, Introduction to Magnetic Materials. Reading,MA: Addison-Wesley, 1972.

[7]R. M. A. Dawson, Z. Shen, D. A. Furst, S. Connor, J. Hsu,M. G. Kane, R. G. Stewart, A. Ipri, C. N. King, P. J. Green, R. T.Flegal, S. Pearson, W. A. Barrow, E. Dickey, K. Ping, C. W.Tang, S. V. Slyke, F. Chen, J. Shi, J. C. Sturm, and M. H. Lu,“Design of an improved pixel for a polysilicon active-matrixorganic LED display,” in SID Tech. Dig., 1998, vol. 29, pp.11–14.

[8]F. Delorme et al., “Butt-jointed DBR laser with 15 nm tenability grown in three MOVPE steps,” Electron. Lett., vol. 31, no. 15,pp. 1244–1245, 1995.

[9]S. G. Finn, M. M´edard, and R. A. Barry, “A novel approachto automatic protection switching using trees,” presented at theProc. Int. Conf. Commun., 1997.

[10]R. K. Gupta and S. D. Senturia, “Pull-in time dynamics asa measure of absolute pressure,” in Proc. IEEE InternationalWorkshop on Microelectromechanical Systems (MEMS’97),Nagoya, Japan, Jan. 1997, pp. 290–294.

[11]P. Hedelin, P. Knagenhjelm, and M. Skoglund, “Theory fortransmission of vector quantization data,” in Speech Coding andSynthesis, W. B. Kleijn and K. K. Paliwal, Eds. Amsterdam,The Netherlands: Elsevier Science, 1995, ch. 10, pp. 347–396.

[12]V. Jacobson. (1990, Apr.) Modified TCP congestion avoidancealgorithm. end2end-interest mailing list. [Online]. Available:ftp://ftp.isi.edu/end2end/end2end-interest-1990.mail

[13]R. Jain, K. K. Ramakrishnan, and D. M. Chiu, “Congestionavoidance in computer networks with a connectionless networklayer,” Digital Equipment Corporation, MA, Tech. Rep. DECTR-506, Aug. 1987.

[14]N. Kahale and R. Urbanke, “On the minimum distance ofparallel and serially concatenated codes,” IEEE Transactionson Information Theory, submitted for publication.

[15]A. Karnik, “Performance of TCP congestion control with ratefeedback: TCP/ABR and rate adaptive TCP/IP,” M. Eng. thesis,Indian Institute of Science, Bangalore, India, Jan. 1999.

[16]S. Konyagin, private communication, 1998.

[17]Q. Li, “Delay characterization and performance control of wideareanetworks,” Ph.D. dissertation, Univ. of Delaware, Newark,May 2000. [Online]. Available: qli

[18]N. C. Loh, “High-resolution micromachined interferometricaccelerometer,” Master’s thesis, Massachusetts Institute of Technology,Cambridge, 1992.

[19]D. H. Lorenz and A. Orda. (1998, July) Optimal partitionof QoS requirements on unicast paths and multicast trees.Dept. Elect. Eng., Technion. Haifa, Israel. [Online]. Available:ftp://ftp.technion.ac.il/pub/supported/ee/Network/lor.mopq98.ps

[20] S. M. Metev and V. P. Veiko, Laser Assisted Microtechnology,2nd ed., R. M. Osgood, Jr., Ed.Berlin, Germany: Springer-Verlag, 1998.

[21]D. Middleton and A. D. Spaulding, “A tutorial review ofelements of weak signal detection in non-Gaussian EMI environments,”National Telecommunications and Information Administration(NTIA), U.S. Dept. of Commerce, NTIA Report86-194, May 1986.

[22]T. J. Ott and N. Aggarwal, “TCP over ATM: ABR or UBR,”unpublished.

[23]J. Padhye, V. Firoiu, and D. Towsley, “A stochastic model ofTCP Reno congestion avoidance and control,” Univ. of Massachusetts,Amherst, MA, CMPSCI Tech. Rep. 99-02, 1999.

[24]Patashnik. (1988, Feb.) Bibtexing. btxdoc.pdf. [Online]. Available:

[25]L. Roberts, “Enhanced proportional rate control algorithmPRCA,” ATM Forum Contribution 94-0735R1, Aug. 1994.

[26]H. E. Rose, A Course in Number Theory. New York, NY:OxfordUniv. Press, 1988, ch. 3.

[27]W. V. Sorin, “Optical reflectometry for component characterization,”in Fiber Optic Test and Measurement, D. Derickson,Ed. Englewood Cliffs, NJ: Prentice-Hall, 1998.

[28]V. Valloppillil and K. W. Ross. (1998) Cache arrayrouting protocol v1.1. Internet draft. [Online]. Available:

[29]M. Wegmuller, J. P. von der Weid, P. Oberson, and N. Gisin,“High resolution fiber distributed measurements with coherentOFDR,” in Proc. ECOC’00, 2000, paper 11.3.4, p. 109.

[30]M. Yajnik, S. B. Moon, J. Kurose, and D. Towsley, “Measurementand modeling of the temporal dependence in packet loss,”in Proc. IEEE INFOCOM’99, vol. 1, New York, NY, Mar. 1999,pp. 345–352.

[31]M. S. Yee and L. Hanzo, “Radial basis function decisionfeedback equaliser assisted burst-by-burst adaptive modulation,”in Proc. IEEE Globecom ’99, Rio de Janeiro, Brazil, Dec. 5–9,1999, pp. 2183–2187.

[32]S. Zhang, C. Zhu, J. K. O. Sin, and P. K. T. Mok, “A novelultrathin elevated channel low-temperature poly-Si TFT,” IEEETransactions on Electron Devices, vol. 20, pp. 569–571, Nov.1999.