INFINITY® ORDERING CHECKLIST
Sold to: / Ship to:Acct #:
Date:
Date Required:
Phone #:
Shipping Instructions: / Cust P.O. #:
Via: / Contract #:
Delivery Phone: / Project #:
Check One: / Check One: / Finish to Match? / Yes / No
New
/ Commercial / Match to:Retrofit / Institutional / Project Name:
Both / Industrial / Owner Name:
Residential
Substrate:
DensGlass Gold - Contact local Georgia Pacific Distributor
Air/Water-Resistive Barrier:
Product / Approx. Sq. Ft. Coverage / Unit Pricing / QuantityBackstop® NT - Texture
Backstop® NT - Smooth / 250 – 300
400 – 500
(60 lb pail, approximate sq. ft. coverage varies depending upon the substrate type)
Grid Tape™
/ N/A(295 lin. ft/roll - minimum purchase of full carton - 12 rolls per carton)
Flashing Tape™ - 4" / N/A(75 lin. ft/roll - minimum purchase of full carton - 9 rolls per carton)
Flashing Tape - 6" / N/A(75 lin. ft/roll - minimum purchase of full carton - 6 rolls per carton)
Flashing Tape - 9" / N/A(75 lin. ft/roll - minimum purchase of full carton - 4 rolls per carton)
Flashing Tape Surface Conditioner™ / 900(1 gallon pail)
1
Product / Approx. Sq. Ft. Coverage / Unit Pricing / QuantityAquaFlash®
8 lb pail
40 lb pail / 133 lf - 300 If
667 lf - 1500 lf
Approximate Sq. Ft. coverage varies depending upon width of mesh
AquaFlash Mesh - 4" / N/A(180 lin. ft/roll - minimum purchase of full carton - 9 rolls per carton)
AquaFlash Mesh - 6" / N/A(180 lin. ft/roll - minimum purchase of full carton - 6 rolls per carton)
AquaFlash Mesh - 9" / N/A(180 lin. ft/roll - minimum purchase of full carton - 4 rolls per carton)
Cavity Components:
Product / Approx. Sq. Ft. Coverage / Unit Pricing / QuantityI. S. Vent Assembly™
/ N/A(2" x 6" x 12" - 16 pieces per case - required at the base of walls and the base of horizontal compartments)
I. S. Starter Strip
/ N/A(2" x 6" x 48" - 27 pieces per case - used at the base of walls and the base of horizontal compartments to fill in between I. S. Vent Assemblies. It is also used at the heads of windows, doors, and penetrations - configured to receive I. S. Track and I. S. Vent Track™)
I.S. Vent Track
/ N/A(40 pieces per case - 10' long pieces of "J" shaped starter track WITH vent holes. The vent holes are centered over all vent assemblies. In other words, you need equal numbers of I. S. Vent Track and I. S. Vent Assemblies)
I. S. Track
/ N/A(40 pieces per case - 10' long pieces of "J" shaped starter track WITHOUT vent holes. This track is used to fill in areas between I. S. Vent Track and at the heads of all penetrations. Note: When possible a continuous piece of track should be used at the head of all penetrations - DO NOT USE leftover track from other areas)
Dryvit Adhesive / varies with adhesive(Select one of the following; Primus - 60 lb pail 240 sq. ft notch trowel/190 sq. ft. ribbon and dab; Genesis - 60 lb pail 260 sq. ft notch trowel/215 sq. ft. ribbon and dab; Primus DM, Genesis DM or Genesis DMS - 50 lb bag 90-110 sq. ft.)
AP Adhesive
/ 110 lin. ft(29 oz./tube - at 3/8" beads - minimum purchase of full cartons - 12 tubes per carton - used to attach and seal I. S. Vent Track and I. S. Track to air barrier)
1
Product / Approx. Sq. Ft. Coverage / Unit Pricing / QuantityI. S. Insulation Board™ / 8
(2" x 2' x 4' - vertical grooves are factory cut into the back of the foam 1/4" deep by 1" wide, positioned at 12" on-center - see attached Detail IS 0.0.05. Note: THE GROOVES IN THE FOAM MUST BE VERTICALLY ALIGNED ON THE WALL - contact approved Infinity foam supplier to order foam)
I. S. Insulation Board Closure Blocks / N/A(2" x 12" x 24" or 2" x 6" x 24") (2” x 12” x 48 or 2” x 6” 48”) - used around all openings, top of horizontal compartments, alternating sides of outside corners and for vertical compartment boundaries - contact approved Infinity foam supplier to order foam)
Note: Vertical Closure Blocks are 24” high, horizontal Closure Blocks are 48” wide.
Rainscreen:
Base Coat –
I. S. Base™
/ 140 - 160(60 lb/pails - used as the base coat to embed reinforcing mesh - mixed 2 parts I. S. Base to 1 part cement)
Reinforcing Mesh –
Corner Mesh 9 1/2" / N/A(50 lin. yds)
Detail Mesh® 9 1/2" / N/A(50 lin. yds.)
I. S. Reinforcing Mesh™
/ 475(39.5 lin. yds. - 5 oz. - gray color for identification)
Panzer® 15 - 48" / 300(25 lin. yds. - must have a layer of I. S. Mesh installed over the Panzer 15)
Panzer 20 - 48"
/ 300(25 lin. yds. - must have a layer of I. S. Mesh installed over the Panzer 20)
Infinity Finish: Color:
Product / Approx. Sq. Ft. Coverage / Unit Pricing / QuantityInfinitex QP® / 130 - 150
Infinitex SP® / 120 - 140
Infinitex SPF® / 150 - 170
Infinitex ADB® / 180 - 200
Product / Approx. Sq. Ft. Coverage / Unit Pricing / Quantity
Ameristone™
/ 60Stone Mist®
/ 70 - 80TerraNeo® / 90 - 100
Lymestone™
/ 150(Sq. ft. will varies depending upon application technique)
Custom Brick™
Polymer Finish
/ N/AColor Prime™
/ 1400 - 1600Sealants:
Dow 790, Dow 791, Dow 795 with Dow 1200 Prime Coat - Contact local Dow Corning Distributor
Tremco Spectrem 1, Spectrem 3, or Spectrem 4 with TREMPrime Silicone Porous Primer - Contact local Tremco Distributor
Other Materials:
Product / Approx. Sq. Ft. Coverage / Unit Pricing / QuantityPortland Cement
Type I or II / N/A
(Contact local supplier)
NOTE:
*All product coverages are estimates. Some coverage rates could vary depending upon waste, environmental conditions at the time of application, and job design. Coverage rates for each product should be determined when the job site mock-up is completed. The mock-up requirements must be followed, especially when a specialty finish is used.
*All finish orders of the same color for the same project should be placed all at once to insure maximum color consistency.
*Be sure to order all additional required finish products such as Color Prime and SealClear™ when needed. Color Prime or Demandit® is required for all sealant joint surfaces.
*Dryflex® should be used on all sills, parapets and other sloped surfaces.
3
4 - Infinity ordering checklist.doc 5 R1:02/03/11