CORRIGENDUM
Reference our Short Tender Notice # 16/2008 published in daily “The News” and daily “The Jang” on 04/06/2008. Kindly note that specifications of the equipment mentioned in Schedule of Requirement of the tender documents # 16/2008 dated 05/06/2008 has been amended. Revised schedule of Requirement / detail may be obtained either from the office of undersigned (during working hours) or download from www.ppra.org.pk or www.pral.com.pk. Last date for submission of bids is also being extended from 21/06/2008 to 28/06/2008. The bids must be reached to the office of undersigned on 28/06/2008 before 1400 hours. The bids shall be opened on 28/06/2008 at 1430 hours in the presence of bidder’s representatives. All other terms and conditions mentioned in tender documents # 16/2008 dated 05/06/2008 remain unchanged.
Manager (Administration)
House # 15, Street # 19, F-6/2, Islamabad.
Ph:051-9208687
CORRIGENDUM
SCHEDULE OF REQUIREMENT
TENDER # 16/2008 DATED 05/06/2008
BILL OF QUANTITIES
LOT 1: Rack Servers & Rack
Note: vendors are not allowed to quote any End of Life (EOL) products. Non compliance to this makes them non responsive. Vendors must ensure the delivery of equipment within 4-5 weeks.
Category 1 Servers
Quad Core 64-Bit Servers
DESCRIPTION OF RACK SERVER / Quantity4 x Intel Xeon Quad Core 2.93 GHz (7350) Processors or Higher / 4
64 GB Memory Upgradeable up to 128GB
1066 MHz FSB or Higher
4 U Form Factor
8 MB Cache Per Processor or Higher
5 x 146 GB SAS 15K (preferable) HDD Hot Swappable/Pluggable
512 MB (preferable) RAID Controller With Level 5 Support
2 X 4 GB/Sec FC Cards
4 x Gigabit Ethernet ports (should support teaming for failover and load-balancing)
DVD/CDRW (DVD RW+- Preffered)
Hot-Swap Redundant Power Supply
Standard Server Management Software
Microsoft Windows 2003 64-Bit ENT Edition with 25 Cals and Media
3 Years on site comprehensive Warranty & Support
Category 2 Servers
Quad Core 64-Bit Servers
DESCRIPTION OF RACK SERVER / Quantity4 x Intel Xeon Quad Core 2.93 GHz (7350) Processors or Higher / 10
32 GB Memory Upgradeable up to 128GB
1066 MHz FSB or Higher
4 U Form Factor
8 MB Cache Per Processor or Higher
5 x 146 GB SAS (15K preferred) HDD Hot Swappable/Pluggable
512 MB (preferred) RAID Controller With Level 5 Support
2 X 4 GB/Sec FC Cards
4 x Gigabit Ethernet ports (should support teaming for failover and load-balancing)
DVD/CDRW (DVD RW+- Preffered)
Hot-Swap Redundant Power Supply
Standard Server Management Software
Microsoft Windows 2003 64-Bit ENT Edition with 25 Cals and Media
3 Years on site comprehensive Warranty & Support
4. Racks (Same Brand as of Server) with Accessories
DESCRIPTION / Quantity42U Rack with Cables, Fan kit, Rails & Fittings as Required / 3
Min 8 Port KVM Switch With Cables & Power
32 Amp PDU with Six Power Bars
17” 1 U TFT Console Purpose built for Servers With Touchpad Mouse & Keyboard
Blanking Panels for blank spaces
Turnkey Installation of Servers and other Equipment in Racks As Per Requirement
Lot 2: Rack Conversion Kit for Dell 2900 series servers
DESCRIPTION / QuantityRack Conversion Kit for dell 2900 Series Desktop servers / 8
LOT 3: SAN for DR Metro Site
Note: vendors are not allowed to quote any End of Life (EOL) products. Non compliance to this makes them non responsive. Vendors must ensure the delivery of equipment within 4-5 weeks.
1. Storage Area Network
PRAL is planning to establish DR Metro Site and require real time replication/mirroring of our primary SAN with Metro SAN. Currently we have EMC CX-300 Storage Box and vendors have to device a solution which is interoperable with our existing storage box. PRAL RPO is Zero Minutes
· Min 3.0 TB usable (RAID 5) with one Hot Spare user space is required which should be upgradeable up to 25 TB using 300 GB FC Disk Drives excluding Storage OS
· 300 GB FC disk drives
· 4GB/S FC Architecture
· Min 4 FC Host ports;
· System Interface should be FC
· Support for RAID Level 0, 1, 1/0, 3, 5, 6
· Redundant Power Supply
· Rack Mountable
· All Major OS Support (windows + Unix)
Following Business/Software functionalities are required
· Synchronous Replication/ mirroring of Primary storage with Metro SAN an RPO=0 solution is required.
· Recoverable locally to any point in time with continuous data protection, and remotely to a specific point in time with continuous 2-way Synchronous replication/mirroring
· synchronous replication/mirroring between two sites (Primary and Metro Site)
· Appliance based replication/mirroring solution is required
· Deliver a single business continuity solution with guaranteed consistency across heterogeneous storage.
· Dynamic load balancing across multiple paths;
· Automatic channel failover from host to the storage;
· Automatic detection and recovery of failed paths;
· Complete Storage Management Software Suit for min 10 servers;
· Online upgrades of storage software and micro code;
· Complete configuration, management, and event notification software;
· Constant system Performance monitoring, remote diagnostics & Management Software.
Storage Area Network (SAN)
DESCRIPTION / QuantityTurnkey Installation and Integration with Metro Disaster Site
Rack Mountable Chassis, 4GB/S FC Architecture, 4 FC Host ports / 1
300GB FC Disks / 1 Pack
RAID controller with Level 0, 1, 1/0, 3, 5, 6 / 1
12 Ports 4GB/S FC Switch / 2
Required Software with accessories / As per requirement
Required cables including FC Cables, connectors and accessories for 10 servers / As per requirement
3 Years on site comprehensive Warranty & Support
2. Tape Library
A complete back up and recovery solution including hardware and all necessary software for taking periodic back up of the data on tape drives with following functionality is required
· System with Continuous Robotics, 2-LTO-4 drives, min 48 media slots
· Auto-loader that allows media to load automatically
· Must support minimum backup rate of 4 GB/s
· Should be able to take backup of data both over SAN and LAN / WAN
· Supplier will also provide media for minimum 10 TB of DATA
· Industry standard Backup & Recovery software is required
Tape Library
DESCRIPTION / QuantityTurnkey Installation and Integration with servers along with user Training is required
Rack Mountable Chassis, FC 4 enabled, 2 LTO-4 Drives, Minimum 48 Media Slots / 1
AC Power Supply / 1
10 TB Storage Media / 1 Pack
Required industry standard Management & Backup software suite with accessories for Oracle 10g, MS SQL and SAN / As per requirement
Required cables, connectors, accessories
3 Years on site comprehensive Warranty & Support / As per requirement
3. Training
Advance Training (4 Engineers) for SAN from certified training specialists in certified training facility is required.
LOT 4: Expansion in current Network Equipment
Note: vendors are not allowed to quote any End of Life (EOL) products, vendors must ensure the delivery of equipment within 4-5 weeks. In addition to this vendors are required to submit engineering document for active/active hierarchical configuration duly wetted by principals
1. Layer 3 Switch (Nortel 8310 Base Chassis)
A layer 3 Ethernet switch in a full redundancy configuration is required to offer continued services and connectivity to the servers at all times. This switch should be able to provide resiliency to our already installed ERS 8310 Layer 3 Switch
· Modular chassis based hardware architecture (10 slots or more).
· Quality of Service (QoS) features to support mission-critical applications.
· At least 300+ Mpps performance
· Switching Backplane capacity 400+ Gbps.
· Efficient intranet multimedia and multicast support through Protocol Independent Multicast (PIM) and Internet Group Management Protocol (IGMP), deliver end-to-end, scalable bandwidth for multimedia and multicast applications.
· Support for multiple levels of network resiliency and serviceability.
· Device-level fault tolerance should be supported for all hardware components.
· Shall support IP based, MAC based and port based VLANs.
· Wire-Speed ACL support
· Fully Manageable via SW, SNMP, WEB GUI.
· Dynamic/Private VLANs Support.
· vendors are required to quote any additional software for our existing box for Active/Active configuration
DESCRIPTION / QuantityLayer 3 Switch Chassis / 1
(N+1) AC Power Supply
2 X Switching Fabric/Central Processing modules with 16 SFP ports (8 on each CP)
5 X 48 10/100/1000 Ethernet Modules
32 x 1000 Base TX GBIC Modules for ERS 8310
Required Software with accessories for active/active configuration, vendors are required to quote any additional software for our existing box for Active/Active configuration / Complete as required for Full Dynamic Routing with RIP and OSPF
Required cables, connectors, accessories
3 Years on site comprehensive Warranty & Support
2. Layer 2 Access Switch Specifications
·
· Fixed Configuration in 24 X10/100/1000 Ports.
· Stackable using Stack ports or uplink Ports
· 20 Gbps or more throughput
· 6.5 Mpps or more forwarding Rate
· VLAN Support
· Multi-link Trunkingor equivalent IEEE 802.3ad Link aggregation protocol (LACP)
· Port Mirroring
· Spanning Tree Protocol
· QOS Support
· Management: Web Based Management; SNMP v1/v3; SSH
· 02 Gigabit 1000 Base TX uplinks Ports
DESCRIPTION / QuantityLayer 2 Access Switch Specifications / 4
24 x 10/100/1000 Ethernet Layer 2 Switch Chassis with Stacking Cable
2 X 1000 Base TX Uplink ports
AC Power Supply
Required Software with accessories
Required cables, connectors, accessories
3 Years on site comprehensive Warranty & Support
3. Internet Link Load Balancing Switch
A WAN link load balancing switch is required to balance In-bound and Out-bound internet traffic from multiple ISP’s Links, Link load-balancing switch should load balance External traffic by directing DNS queries to reflect link status.
DESCRIPTION / QuantityInternet/WAN link load balancing Switch / 2(1+1)
1 X AC Power Supply
2 X 1000 Base TX Ports
8 X 10/100 Base TX ports
Required Software for WAN link load balancing, bandwidth management, shaping and rate limiting / As per requirement
Required cables, connectors, accessories
3 Years on site comprehensive Warranty & Support
4. Firewall (Juniper SSG550)
Juniper SSG550 Firewall in a full redundant configuration is required to offer continued services and connectivity. This Firewall should be able to provide resiliency to our already installed Juniper SSG 550 State full Firewall
DESCRIPTION / QuantityFirewall Base Chassis / 1
2 X AC Power Supply
2 X 8 x1000 Base TX ports Modules
1 GB RAM
1000 VPN Tunnels
Unrestricted Software as per requirement
Required Software with accessories for active/active configuration, vendors are required to quote any additional software for our existing box for Active/Active configuration
3 years Subscription for AV, Deep Inspection, Web Filtering & Anti-Spam
Required cables, connectors, accessories
3 Years on site comprehensive Warranty & Support
5. Router (Juniper 6350 Series)
Router
· Modular hardware architecture of the rack mountable chassis
· Minimum 6 slots chassis
· 1GB RAM
· Stateful Packet Inspection Firewall support
· Must support multiple WAN interfaces like Serial, E1, Fractional E1, FE, GE
· WAN encapsulation support FR, HDLC, PPP, MLPPP
· Must support IP, PPP, Frame Relay, and NAT etc
· Layer 3 support
o IPv4 and IPv6 support, including IPv4-IPv6 tunnels
o Static routing, RIPv1/2, RIPng for IPv6, OSPFv2 and v3, BGP4/4+
o Policy-based routing
o MPLS
o Inter-VLAN routing
o High availability: VRRP, redundant router connections
· ACL, NAT, GRE Tunneling,
· Quality of Service
o RED, WRED, DiffServ, bandwidth guarantee/sharing, flow monitoring
o Traffic Policing
o 8 level Priority Class Based Queuing (per IP address/subnets, Ports, DSCP and ToS bits, VLAN ID (802.1q), VLAN Priority (802.1p)
o Frame Relay traffic shaping and policing
o VLAN Classification (port, subnet or protocol-based)
· High Availability support
· Must support IP services like IP VPNs, IPSec
· Must support Routing protocols; RIPv1/v2, OSPF v2, BGP, Multicast
· System management:
o Web Based (HTTP & HTTPS)
o CLI
o SSH & Telnet
DESCRIPTION / QuantityRouter Base Chassis / 2(1+1)
2 X AC Power Supply
1 X 8 X 10/100/1000 Ethernet ports module
Required Software with accessories, As per requirement above, 3Des Support + VPN and Stateful Firewall
Required cables, connectors, accessories
3 Years on site comprehensive Warranty & Support
6. Network Rack with Accessories
DESCRIPTION / QuantityBranded Imported 42U Rack APC or equivalent brand with Fans and two Power Bars with ten outlets each
Turnkey Installation of Network equipment in Rack / 2
As Per Requirement
7. Training
Advance Training (3 Engineers) for Link load balancing switches, Juniper J Series Routers, Nortel Alteon Application Load Balancing switch, Juniper SSG Firewall and Nortel Layer3 switch from certified training specialists in certified training facility is required.
8. Direct support accouts with the principal is required for the period of three years.
LOT 5. DDOS Prevention
1. DDOS Prevention Appliance
DESCRIPTION / QuantityIndustry standard DDOS Prevention device is required with proven capability to monitor and block DDOS attack with GigE support. appliances like Riorey or equivalent is required / 1
4 X 10/100/1000 Ethernet Ports
3 Years on site comprehensive Warranty & Support / As Per Requirement
2. Training for DDOS Appliance
Advance Training (2 Engineers) for DDOS prevention device from certified training specialist in certified training facility is required.