ZH-Y1 Manual
Display setting:
Three sending ways:
1. USB sending.
2. WIFI sending.
3. LAN cable sending.
How to set the IP address?
Display setting:
①. ZH-Y1 first need to connect display with PC together by the LAN cable.
②. Modify the PC's IP address into 192.168.1.15. After the IP address is modified successfully, you can open the software to do display setting.
③. Open the software, click on "Settings" - "Display Setting".
④. Click on "Find Y1". After the card information appear, click on "Close".
⑤. Click on "Screen Setting".Passcode is 168.Click on "Setting Intelligent", and modify the corresponding parameters by following the software instruction. Then click SendToHW and SaveToHW. After this, you have finished the display setting. Now it’s time for you to input videos or pictures into software. In the following, I will introduce three types of sending ways.
Note:
After you have done the display setting this time, there is no need to set the parameters again for later video update.If you change the PC, you just need to change the PC display sizeinto the actual size of your PC display, then you can edit the contents and send programs.
Three sending ways:
1. USB sending.
①. Edit the program content;
②. Insert your U disk into PC USB port;
③. Click on "File", then click on "Export Current Project to USB". It will save videos into the U disk.
④. Insert the U disk into the USB port of the ZH0-Y1 card. The green indicator light pf the ZH-Y1 card will flash quickly; when it stops flashing, it means uploading successfully. Then you can take out the U disk from the port.
Note: If you use SD card to send, all steps are same with this procedures.
2. WIFI sending.
①. At first, find and connect to the ZH-Y1 WIFI signal on the PC.
②. Then open the software, click on "Settings" - "PlayerBox Cluster Manage"
③. On the cluster management interface, click "send", when it finishes uploading, the screen will display what you have edited.
3.LAN cable sending.
①. Click on "Settings" --- "PlayerBox Cluster Manage"
②. Enter the cluster management interface, select LED1, then click on "Send". When it finishes loading, the screen will display what you have edited in the software.
How to set the IP address?
Take Win10as an example:
①. Click on the Network Connectionicon in the lower-right corner of the taskbar of your PC, and open the window, then lick "Open Network and Sharing Center"
②. In the View Activity Network column, click on "Connections" and enter the following interface.
③. Then open the "Properties" box, and double click on the "Internet Protocol version 4 (TCP / IPv4)" project.
④. Then you will enter into this Internet Protocol Version 4 (TCP/IPv4) Properties interface. And here you can modify the IP address into 192.168.1.15; Subnet mask is 255.255.255.0; the Default gateway is 192.168.1.1. Then you need click on the “OK”.