Select Secure Wireless and Click Connect

DRAFT

SECURE_WIRELESS

MS Vista Connection instructions.

Bring up the Connect to a network by right clicking on the network icon in the system tray located in the lower right corner of the screen.

Select secure_wireless and click connect.

Type in the passphrase. The network key/ passphrase is: ccsnisnowcsn

Click connect.

Click Close.

Click close again.

Upon opening your browser, you will be redirected to an authentication page below.

If you are a faculty or staff:

· Select CSN as the domain

· The credentials (username and password) will be the same as you email username and password.

If you are a student:

· Select STUDENT as the domain

· The credentials (username and password) will be the same as those which you use to access lab computers.

Click on Download Clean Access Agent 4.1.2.0

Click on Run.

Click on Run again.

Click Next.

Click on Next.

Click on Install.

You will notice that the files are beginning to install.

IMPORTANT!

From this point forward, you will see this icon in the system tray of your system. If you click on this icon, it will ask you to authenticate to gain internet access. Going forward, you will only need to make sure you authentication using this icon to gain network connectivity. If you do not, you will be prompted to reinstall the application even if you have. It is important for you to logon before attempting to access the network from this point forward.