Dear Hannah Challenge #5

E-6 Sequoyah’s Horse

Now, folks, how much easier do you want?<G> Even rotary cutting is a

snap.

Rotary Cutting

  1. Cutting Instructions

1)Background

a)two - 1.5 X 2.25 inches

b)two - 1 X 5 inches

2)Dark Print: two – 1 X 5 inches

3)Medium Print

a)one – 1.5 inch square

b)two – 1.25 X 5 inches

  1. Assembly

1)Lay the block out with right sides facing you

2)Assemble the center strip by sewing the two pieces of

background to the center square

3)Chain the three remaining sets of strips and sew to the

center strip

4) Press

A-3 Dragon Tail

This is a good block to practice a new technique, such as Linda

Hershfield’s method for circles, diamonds and melons. She has

graciously given me permission to reprint her letter in this weeks’

Challenge.

I was taught to do circles by making a template out of mylar plastic, or
thin cardboard, or oaktag or anything similar in weight and that can be
ironed. I trace the circle on one of the above, and cut it out and I punch a
hole right in the center.

I use an emery board to smooth all the edges.
Note: What you see on your template is what you get on your circle.
Lay the circle on the wrong side of your fabric and cut out leaving

approx. a 3/8 inch seam allowance.
Then knot a piece of thread...... any color will do (it won't
show)...... and take a small running stitch around the circle close to the

edge without fraying it.
Next, put your circle back in the center of the fabric and pull...... pull
tight but not tight enough to break the thread. Turn over the fabric
and see if your circle is nice and smooth. If not, then just pull a little
more. Then take the piece to your iron and press nice and firm. I
then use Magic Sizing on the back and press again.
Now I take the end of a paintbrush or a chopstick and place it in the
hole that I punched and pull out the template. At this point, you might

have to slightly pull your thread again but your circle should be as close

to perfect as it can get.

Backstitch once or twice so the thread won't move at this point.
Then place it on your piece and applique.
I have been using this method for melons, diamonds, hearts (I skip the
"v" and just needle turn that) but it works well. At least the bottom point
is a good one. I've also used this method on ovals, and a few irregular

Shaped pieces.
Just practice a few times and I'm sure you'll get the hang of it and you
will then know if you like this method or not. It has definitely
improved my applique!”

Thank you Hersheybar, for sharing your method with us!

Have fun making these two blocks!