PHysical Conditions & Safe Work Practices Checklist – Logging
Physical Conditions & Safe Work Practices Checklist – Logging
/Company: ______
Conducted by: ______Date: ______
/Standard
/ Ref.* / Hazard(A,B,C)** /
Comments
CONVENTIONAL LOGGING
L 101 / Chainsaw in good condition / 39 (a)(b)L 102 / Proper chainsaw starting procedures / 39 (c)
L 103 / Saw chain sharpened and maintained correctly
L 104 / Felling aids used correctly
L 105 / Proper limbing and topping techniques / 109 (c)
L 106 / Proper notching and backcutting techniques
L 107 / Proper felling techniques and use of effective felling pattern
L 108 / Saw carried correctly
L 109 / Escape route cleared and used / 109 (a)(iv)
L 110 / Appropriate landing area prepared and cleared of hazards / 108
L 111 / Danger zone observed / 109 (a)(i)
L 112 / Chicots/freestanding trees/hang-ups/snags/springpoles dealt with safely / 109
(a)(iii)
L 113 / Certification underway or complete / 104-106
*Notes: RIE - Regulations for Industrial Establishments (Unless otherwise stated, section numbers are from here)
OH&S Act - Occupational Health and Safety Act FAR - First Aid Regulation 1101 FCR - Fire Code Regulations
FFPA - Forest Fire Prevention Act HTA R614 - Highway Traffic Act Regulation 614 on Securing Loads
GHC - Gasoline Handling Code under the Energy Act TDG - Transportation of Dangerous Goods Act
** Hazard Classification:
A: A condition or practice likely to cause permanent disability, loss of life or body part and/or extensive loss of structure, equipment or material.
B: A condition or practice likely to cause serious injury or illness, resulting in temporary disability or property damage that is not extensive.
C: A condition or practice likely to cause minor; non-disabling injury or illness or non-disruptive property damage.
This Self-Evaluation Assessment is to be completed by all firms taking part in the 2010 WSN Safety Group who have achieved at least one SWO recertification and must be submitted by June 30, 2010
Standard
/ Ref.* / Hazard(A,B,C)** /
Comments
SKIDDING (CABLE & GRAPPLE)
L 201 / Circle check completedL 202 / Fire extinguisher charged/other fire-fighting equipment readily available as required / FFPA
L 203 / First aid kit available and inspected / FAR
L 204 / No loose equipment in cab
L 205 / Machine secured when stopped/blade down / 57, 58
L 206 / Skidding speed/safe skidding / 112
L 207 / Seat belt worn if required
L 208 / Danger zone observed
L 209 / Chicots/freestanding trees/hang-ups eliminated safely
L 210 / Spear poles observed
L 211 / Mounting/dismounting (3-point contact)
L 212 / Handholds/foothold/machine guarding in good condition
L 213 / Winch, mainline and chokers in good condition and used properly
L 214 / Machine lockout procedure understood and lockout equipment in place / 75-76
L 215 / General condition of machine / 114
L 216 / Certification underway or complete / 104-106
*Notes: RIE - Regulations for Industrial Establishments (Unless otherwise stated, section numbers are from here)
OH&S Act - Occupational Health and Safety Act FAR - First Aid Regulation 1101 FCR - Fire Code Regulations
FFPA - Forest Fire Prevention Act HTA R614 - Highway Traffic Act Regulation 614 on Securing Loads
GHC - Gasoline Handling Code under the Energy Act TDG - Transportation of Dangerous Goods Act
** Hazard Classification:
A: A condition or practice likely to cause permanent disability, loss of life or body part and/or extensive loss of structure, equipment or material.
B: A condition or practice likely to cause serious injury or illness, resulting in temporary disability or property damage that is not extensive.
C: A condition or practice likely to cause minor; non-disabling injury or illness or non-disruptive property damage.
This Self-Evaluation Assessment is to be completed by all firms taking part in the 2010 WSN Safety Group who have achieved at least one SWO recertification and must be submitted by June 30, 2010.
Standard
/Ref.*
/Hazard(A,B,C)**
/Comments
PERSONAL PROTECTIVE EQUIPMENT (Properly Maintained and Used)
L 301 / Eye protection / 81L 302 / Hearing protection / 139
L 303 / Head protection / 80
L 304 / Hand protection / 84
L 305 / Foot protection / 82
L 306 / Leg protection / 84
L 307 / Fall restraint/fall arrest equipment / 85
L 308 / High-visibility reflective clothing / CSA
L 309 / Other PPE
FIELD GARAGE/SERVICE VEHICLE HAZARD CONTROLS/OTHER COMPANY VEHICLES
L 401 / Fire Extinguisher charged/other fire equipment readily available as required / FCR FFPAL 402 / First aid kit available and inspected / FAR
L 403 / Compressed gas cylinders secured / 49
L 404 / WHMIS labels and MSDSs / OH&S Act 37
L 405 / Eye wash station / 124
L 406 / Lifting/hoisting devices (safety catches on hooks inspected) / 51
L 407 / Condition of tools and equipment / 43, 44
L 408 / Housekeeping / 11
L 409 / Adequate spacing of equipment, vehicles and buildings in case of fire and protect workers
L 410 / Mechanic using safe work practices
L 411 / Drivers of company vehicles using safe driving habits
*Notes: RIE - Regulations for Industrial Establishments (Unless otherwise stated, section numbers are from here)
OH&S Act - Occupational Health and Safety Act FAR - First Aid Regulation 1101 FCR - Fire Code Regulations
FFPA - Forest Fire Prevention Act HTA R614 - Highway Traffic Act Regulation 614 on Securing Loads
GHC - Gasoline Handling Code under the Energy Act TDG - Transportation of Dangerous Goods Act
** Hazard Classification:
A: A condition or practice likely to cause permanent disability, loss of life or body part and/or extensive loss of structure, equipment or material.
B: A condition or practice likely to cause serious injury or illness, resulting in temporary disability or property damage that is not extensive.
C: A condition or practice likely to cause minor; non-disabling injury or illness or non-disruptive property damage.
This Self-Evaluation Assessment is to be completed by all firms taking part in the 2010 SWO Safety Group who have achieved at least one SWO recertification and must be submitted by June 30, 2010.
Standard
/ Ref.* / Hazard(A,B,C)** /
Comments
LOADING / HAULING
L 501 / Circle check completed / 55, 115L 502 / Fire extinguisher charged / FFPA
L 503 / First aid kit available and inspected / FAR
L 504 / Mounting/dismounting (3-point contact)
L 505 / Proper loading/unloading techniques / 56
L 506 / Danger zone observed
L 507 / Handholds/footholds/machine guarding in good condition
L 508 / Seatbelt worn if required
L 509 / Appropriate footwear worn
L 510 / Load secured using proper tie-downs / HTAR614
L 511 / Load is proper height/width/length / 116
L 512 / General condition of trailer and truck
L 513 / Truck lights clean and visible
L 514 / Appropriate signs posted along roadway / 117 (c)
L 515 / Bridge on haul road acceptable / 118
L 516 / Load checkpoints observed
L 517 / Truckers using safe driving practices and speeds
L 518 / Communication adequate and used properly
*Notes: RIE - Regulations for Industrial Establishments (Unless otherwise stated, section numbers are from here)
OH&S Act - Occupational Health and Safety Act FAR - First Aid Regulation 1101 FCR - Fire Code Regulations
FFPA - Forest Fire Prevention Act HTA R614 - Highway Traffic Act Regulation 614 on Securing Loads
GHC - Gasoline Handling Code under the Energy Act TDG - Transportation of Dangerous Goods Act
** Hazard Classification:
A: A condition or practice likely to cause permanent disability, loss of life or body part and/or extensive loss of structure, equipment or material.
B: A condition or practice likely to cause serious injury or illness, resulting in temporary disability or property damage that is not extensive.
C: A condition or practice likely to cause minor; non-disabling injury or illness or non-disruptive property damage.
This Self-Evaluation Assessment is to be completed by all firms taking part in the 2010 WSN Safety Group who have achieved at least one SWO recertification and must be submitted by June 30, 2010
Standard
/ Ref.* / Hazard(A,B,C)** /
Comments
MECHANICAL HARVESTING EQUIPMENT (Feller Buncher, Delimber, Processor, etc.)FORESTRY PIT AND ROAD CONSTRUCTION EQUIPMENT (Backhoe, Loader, Grader, Gravel Truck, etc.)
L 601 / Circle check completedL 602 / Fire extinguisher charged/other fire fighting equipment readily available as required / FFPA
L 603 / First aid kit available and inspected / FAR
L 604 / Loose equipment in cab
L 605 / Emergency exit in place
L 606 / Handholds/footholds/machine guarding in good condition
L 607 / Danger zone observed / 60
L 608 / Mounting/dismounting (3-point contact)
L 609 / Chicots/overhead hazards acted upon safely
L 610 / Appropriate communication between machines
L 611 / Machine lockout procedure understood and lockout equipment in place / 75-76
L 612 / General condition of machine / 54, 56-60
L 613 / Mechanical Harvesting Equipment Operator or Forestry Pit and Road Construction (MH/FPRCEO) certification underway or complete / 104 - 106
L 614 / Seatbelt worn if required
L 615 / General condition of machine, ROPS and FOPS
L 616 / Drivers of vehicles using safe driving habits and traveling at appropriate speeds
L 617 / Loads properly secured for travel
L 618 / Gravel/sand pits properly site prepared, excavated & sloped / OH&S Act Reg 854
*Notes: RIE - Regulations for Industrial Establishments (Unless otherwise stated, section numbers are from here)
OH&S Act - Occupational Health and Safety Act FAR - First Aid Regulation 1101 FCR - Fire Code Regulations
FFPA - Forest Fire Prevention Act HTA R614 - Highway Traffic Act Regulation 614 on Securing Loads
GHC - Gasoline Handling Code under the Energy Act TDG - Transportation of Dangerous Goods Act
** Hazard Classification:
A: A condition or practice likely to cause permanent disability, loss of life or body part and/or extensive loss of structure, equipment or material.
B: A condition or practice likely to cause serious injury or illness, resulting in temporary disability or property damage that is not extensive.
C: A condition or practice likely to cause minor; non-disabling injury or illness or non-disruptive property damage.
This Self-Evaluation Assessment is to be completed by all firms taking part in the 2010 WSN Safety Group who have achieved at least one SWO recertification and must be submitted by June 30, 2010
Standard
/ Ref.* / Hazard(A,B,C)** /
Comments
OTHER
L 701 / Fuel tanks in trucks or trailers have proper labeling / GHC & TDGL 702 / Adequate fire equipment and trained personnel during fire season / FFPA Reg 207
L 703 / Other (specify)
*Notes: RIE - Regulations for Industrial Establishments (Unless otherwise stated, section numbers are from here)
OH&S Act - Occupational Health and Safety Act FAR - First Aid Regulation 1101 FCR - Fire Code Regulations
FFPA - Forest Fire Prevention Act HTA R614 - Highway Traffic Act Regulation 614 on Securing Loads
GHC - Gasoline Handling Code under the Energy Act TDG - Transportation of Dangerous Goods Act
** Hazard Classification:
A: A condition or practice likely to cause permanent disability, loss of life or body part and/or extensive loss of structure, equipment or material.
B: A condition or practice likely to cause serious injury or illness, resulting in temporary disability or property damage that is not extensive.
C: A condition or practice likely to cause minor; non-disabling injury or illness or non-disruptive property damage.
This Self-Evaluation Assessment is to be completed by all firms taking part in the 2010 WSN Safety Group who have achieved at least one SWO recertification and must be submitted by June 30, 2010
.