BATHROOM PLANNING

FORM 6: JOB SITE INSPECTION

The information on this form needs to be collected through a thorough inspection of the existing structure and/or construction documents. You are looking for detailed information! Some information may appear to repeat some of the questions on other forms, which were asking for client ideas and preferences. However, use this form to verify specifics at the actual site.

Overall Bathroom

Begin with a floor plan sketch to understand the relationship of spaces and to make notes about structural and mechanical details. See the following questions for additional information to add to your sketch.

FORM 6: JOB SITE INSPECTION

Note the following information on your bathroom sketch.

·  What rooms are above, below, and around the existing bathroom space?

·  Can any of the surrounding space be incorporated into the new plan? If so, how much – exactly?

·  What walls can be changed – moved, removed, or otherwise altered?

·  What fixtures are to remain? Are they to be left in the same location, or can they be moved?

·  Is there cabinetry that is to be left in place or reused in the new design?

·  Which way do the floor joists run? Does the floor seem sturdy and stiff?

·  Are there load-bearing walls to consider?

·  Where does plumbing come into the space?

·  Where are the soil stack and other drain/waste/vent pipes?

·  Where are existing ducts and registers located? Can these be moved?

·  What is the condition of finish materials – floors, walls, and ceilings? Are any of the finish materials to remain unchanged?

·  Is there a view from the bathroom? Is the view from the bathroom important?

Determine the following additional information about the bathroom.

Bathroom is on: north northeast east southeast south

southwest west northwest

If new fixtures are to be installed, are they to be put in the same location as the old fixtures?
If the remodeled bathroom project will impact the exterior of the home, are there any restrictions
to be considered? Will existing siding or roof materials be easy to match?
Are there any home improvements or repairs to be incorporated into the bathroom project, such as
new siding or a roof replacement?
If the home is older than 1978, could there be lead-based paint or asbestos in the existing space?

FORM 6: JOB SITE INSPECTION (CONTINUED)

Structure

What is the construction of the house?
What is the condition of the existing structure? Look for sound and level floors, squareness of
corners, and materials in good condition. Do floors squeak?
Is there evidence of water leaks or pest damage?
What size are the joists and will they be adequate support for the new fixtures?
Are windows and doors in good repair and do they operate smoothly? Are new or replacement
windows and doors to match the existing windows with respect to type, size, style, and material?
Is the home well insulated? Are doors and windows energy-efficient?

Mechanical Systems

Can you relocate any plumbing pipes?
What is the capacity of the plumbing system?
What size are the supply pipes? Is there adequate water pressure?
Is the water of good quality?
Will you be able to add additional fixtures, or higher-capacity fixtures to the existing plumbing?
Where is the water heater? What is its capacity?
Can the soil stack and other drain/waste/vent pipes be relocated if needed?

FORM 6: JOB SITE INSPECTION (CONTINUED)

Where are the traps and what type are they?
Is the home on a municipal or private sewage system? Are there any concerns about system
capacity if the amount of wastewater is increased?
Do the circuits have GFCI (ground fault circuit interrupter) protection?
Is the wiring in good condition?
Can existing receptacles be moved?
If needed, are 240-volt circuits available?
Where is the electrical service panel for the house?
Can additional electrical circuits be added if needed?
How is the existing space heated and cooled? Is the current HVAC (heating, ventilating and air
conditioning) equipment in good condition and adequate in size?
If there will be an increase in the size of the bathroom, will the HVAC system be adequate?
Is there and exhaust ventilation system? Is it adequate in size? How is make-up air provided?
Does all or part of the ventilation system need replacement?

FORM 6: JOB SITE INSPECTION (CONTINUED)

Access

What size are any doors between the bathroom and the exterior of the home? Are there narrow
hallways or sharp turns? Will there be any problems in removing or bringing in large, bulky, and/or
heavy fixtures?
Is there finished living space above or below the bathroom? Will you be able to open up floors,
ceilings, or walls to get access to plumbing, electrical, and HVAC systems?

Construction/Installation Planning

Can fixtures, cabinetry, and materials be stored at the jobsite? How much space is there? Is the
storage secure and protected from the weather?
Where will trash be collected?
How will workers get into and out of the jobsite? Is there carpeting or furniture that needs to be
protected?
Where can workers park? Where can they take breaks or eat lunch?
What about smoking, playing music, eating, and drinking at the job site? What about bathroom
facilities for worker’s use?