Oceanographer: ______

Date:______Period:____

Background

Temperatures on planet earth have been increasing since recording began about 160 years ago. Scientists have not only detected rising temperatures on land surfaces, but they have detected rising temperatures in our oceans as well. Given that over 70% of the Earth is covered by water, there is concern that warming oceans can affect sea level and impact coastal communities around the globe, especially equatorial islands.

Objective

In this activity you will hypothesize how increasingtemperature will affect the volume of water and then conduct an experiment to measure and record data.

Materials

Erlenmeyer flask
Two-hole rubber stopper for flask
Thin, glass pipette with graduated markings
Long thermometer
Portable lamp
100 - 150 Watt light bulb
3.5%NaCl solution

Marker
Stopwatch or clock

Hypothesis

Look at figure 1 and assume the flask has been filled completely with water.Write a hypothesis in an, “If…, then…” statement in the space below about what will happen to the volume of water as heat is applied to the flask of water.

______

______

______

Procedure

  1. Fillthe flask with the coldtap water to about 1cm from the top.
  2. Place the thermometer and glass tube into the rubber stopper as shown in Figure 1 above.
  3. Place the rubber stopper (with tube and thermometer) into the mouth of the flask. The water should rise a short way up the glass tube. Be sure there is not a gap between the surface of the water and the bottom of the rubber stopper.
  4. Record the initial temperature and volume of water in the pipette in the data table.
  5. Place the lamp so that it is facing the flask. Do not shine the lamp on the thermometer above the flask.

Record the initial temperature in the table below at time "0".

  1. Turn on the heat lamp and record the temperature and water level at one minute intervals.
  2. Repeat steps 1-5 with a cold salt water solution (3.5% NaCl).

Data Table 1 – Tap Water

Time (minutes) / 0 / 1 / 2 / 3 / 4 / 5 / 6 / 7 / 8 / 9 / 10 / 11 / 12 / 13 / 14 / 15
Temperature (°C)
Initial Pipette Volume (mL)
Change in pipette volume (observed-initial)
Percent change in volume (ΔV%)*

*change in pipette volume/total beginning volume in flask

Table 2 – 3.5% NaCl Salt Water

Time (minutes) / 0 / 1 / 2 / 3 / 4 / 5 / 6 / 7 / 8 / 9 / 10 / 11 / 12 / 13 / 14 / 15
Temperature (°C)
Initial Pipette Volume (mL)
Change in pipette volume (observed-initial)
Percent change in volume (ΔV%)*

*change in pipette volume/total beginning volume in flask

Analysis

Using the grid provided, you will construct a graph to help analyze the data from your experiment. Since temperature is the independent variable that we are investigating, write the temperature values you recorded on the horizontal axis, the x-axis. The percent change in the volume of water is dependent on the temperature of the water, so volume is the dependent variable and should be labeled on the vertical axis, the y-axis. Label your axes with the appropriate units included and be sure to include a descriptive title with your graph.

Draw a line graph showing the effect of temperature on the volume of water. You will graph both your average percent change in volume and the class average using the data for both the tap water and the 3.5% NaCl salt water solution. Use a different colored pencil for each of the four lines and be sure to indicate what each color represents in a key. (Use pencil!)

Title ______

Results

1. Describe the overall trend in the graph. What is the relationship between temperature and water volume?
______

______

______

2. Compare the results from Part 1 with tap water with the results from Part 2 with the 3.5% NaCl solution. How did the class averages compare for the two conditions, tap and salt water? Did the volume change at the same rate in both conditions?

______

______

Conclusion & Application

3. How does this lab model sea level rise with warming temperatures?
______

______

4. Which part of the lab was a better model for thermal expansion and sea level rise? Explain your answer.

______

5. How can we change the model to make it a better fit for what we are observing in sea levels? Explain your answer.

______

6. Why does water volume increase with increasing temperatures?
______

7. How might the change in ocean volume from increasing temperature change coastal areas? Use references for examples to support your answer.
______

______

8. Are there other causes of sea level rise? If so, what are they, describe them, and how they are influencing sea level.
______

______

This lesson was modified from material provided byWindows to the Universe, at theNational Earth Science Teachers Association (NESTA). The Website was developed in part with the support ofUCARandNCAR, where it resided from 2000 - 2010. © 2010 National Earth Science Teachers Association.Windows to the Universe® is a registered trademark of NESTA. All Rights Reserved.Site policies and disclaimer.