Marine Engineering (Paint Application)

Level 2

Awarded by EMTA Awards Limited
Accredited from 6 September 2005to 30 September 2010
Group award number: G80F 22
Standards

This SVQ is based on standards developed by SEMTA. SEMTA draws its membership from the engineering sector.

For further information, please contact the SQA web site.

Structure of the SVQ

The way the SVQ is made up is shown below. The unit title appears in bold and the elements that make up each unit are listed under the unit title.

Mandatory units

Candidates must complete all of these units:

Complying with Statutory Regulations and Organisational Safety Requirements

1Complying with Statutory Regulations and Organisational Safety Requirements

Using and Interpreting Engineering Data and Documentation

1Using and Interpreting Engineering Data and Documentation

Working Efficiently and Effectively in Engineering

1Working Efficiently and Effectively in Engineering

Optional Units

Candidates must complete all of the following units

Carrying Out Patch Preparation of Material Surfaces using Hand and Mechanical Tools

1Carrying Out Patch Preparation of Material Surfaces using Hand and Mechanical Tools

Preparing Marine Coatings for Application

1Preparing Marine Coatings for Application

Carrying Out the Manual Application of Marine Coatings

1Carrying Out the Manual Application of Marine Coatings

Carrying Out the Application of Marine Coatings using Spray Methods

1Carrying Out the Application of Marine Coatings using Spray Methods

Plus

Candidates must complete 2 from the following units

Carrying Out the Preparation of Material Surfaces by Abrasive Blasting

1Carrying Out the Preparation of Material Surfaces by Abrasive Blasting

Preparing Surfaces by Ultra High Pressure (UHP) Water Jetting

1Preparing Surfaces by Ultra High Pressure (UHP) Water Jetting

Carrying Out the Application of Deck Screeds and Other Deck Coverings

1Carrying Out the Application of Deck Screeds and Other Deck Coverings

Carrying Out the Application of Signature Reduction Coverings

1Carrying Out the Application of Signature Reduction Coverings

Applying Fairing, Filling and Specialist Protective Coatings to Marine Components

1Applying Fairing, Filling and Specialist Protective Coatings to Marine Components

There may be publications available to support this SVQ. For more information, please contact:

EMTA Awards Ltd

National Verification Centre

3365 Century Way

ThorpePark

Leeds

LS15 82B

Tel: 01132 601188

Fax: 01132 321159

Website: