Fourth Quarter & Third Quarter (2012) Exam Corrections
Core Curriculum 2009 (4th Edition)
Correction for IRC:
- Core Basic Safety Supplemental OSHA 10-HR Lesson Plans has been updated
Mod 00102-09:
-New Math Calculations for this mod have been uploaded with “Core_2009_Math_Calcs.pdf”
Corrections from Second Quarter 2012 and First Quarter 2012
Core Curriculum 2009
Module 00104-09 Exam
Question 9 Correction
Original question:
9. The first step when using a pneumatically powered nailer is to _____.
a. inspect the nailer for damage
b. load the nails into the nailer
c. check the air compressor
d. read the manufacturer's instructions
The corrected question reads:
9. The first step when using a pneumatically powered nailer for the first time,
is to _____.
a. inspect the nailer for damage
b. load the nails into the nailer
c. check the air compressor
d. read the manufacturer's instructions
-The Answer and Section Reference remain the same
Question 10 Correction
Original question:
10. Saws with fine blades that are excellent for delicate and intricate cutting
are called _____.
a. reciprocating saws
b. saber saws
c. bandsaws
d. worm-drive saws
The corrected question reads:
10. Saws with fine blades that are excellent for delicate and intricate cutting
are called _____.
a. bandsaws
b. saber saws
c. abrasive saws
d. worm-drive saws
-The Answer and Section Reference remain the same
Module 00104-09 Exam
Question 11 Correction
Original Question and Answers:
11. Keep the drill’s air vent clean with a _____.
a. small brush or stick
b. hand-held vacuum cleaner
c. drill bit
d. chuck key
Replacement Answer:
a. small brush
The corrected answer is:
a. small brush
Module 00106-09 Exam
Question 3 Replacement
Original Question and Answers:
3. Which hand signal standards were developed for use with mobile and
overhead cranes?
a. K-SPEC
b. SWL
c. WLI
d. ANSI
Replacement Question and Answers:
3. What hand signal is shown in Figure 1?
a. Swing
b. Retract Boom
c. Stop
d. Emergency Stop
Correct Answer is:
c. Stop