Ceiling to Be SUPATILE SLAT Slatted Ceiling System

Ceiling to be SUPATILE SLAT slatted ceiling system.

Panels to be SUPATILE [select option number or Random] with [Drop in/ Lift & Shift] fixing option.

Panel finish type to be [SUPAFINISH Concept Veneer/ SUPAVENEER Natural Timber Veneer/ Driftwood/ Western Red Cedar/other Solid Timber species] in [specify colour here].

Grid finish to be black and installed as per requirements below

Typical panel size to be [1200x600/600x600/...... / as shown on RCP].

[Delete whichever not applicable:] Panels to have IAT FR, integrated acoustic textile pre-attached/ Lay HP50 Jet Black bulk insulation over ceiling panels/ Ceiling and all services above to be painted out black.

Panels to be Fire Group 3 / 2 / 1 [delete as required] per BCA Specification C1.10 clause 4. [Note that fire groups 1 is only available in the SUPAFINISH finish type and Group 2 in SUPAFINISH and SUPAVENEER.]

Panel installation to be as per manufacturer's instructions and AS/NZS 2785.

[delete whichever of the following paragraphs does not apply]

Grid Requirements for Lift and Shift fixing option:
Grid is to be SUPATILE GRID with main runners installed at 600mm centres with 600mm cross-tees at 1200 or 600mm centres. Grid is to be installed as per Supawood’s “SUPATILE SLAT Lift & Shift Grid & Panel installation procedure”.

Grid Requirements for Drop in Tile fixing option:
Existing grid may be repainted (enamel paint recommended) and used but it is the contractors responsibility to ensure it is able to support the weight of the tiles as well as the service load factors as prescribed in the AS2785. *
Refer to Supawood’s Technical Services Department for tile weights.
*What is required to achieve this will depend on the specific brand, system and configuration currently installed. Typically additional support would be expected to consist of additional hanger supports but the contractor is to take independent advice on this from the original supplier of the existing grid.

Panels are to be FSC or PEFC certified. Documentary evidence in the form of an invoice with each line item annotated with the PEFC/FSC content and supplier’s chain-of-custody number must be provided to the project superintendent for project completion.

Installation to be done by an approved ceiling and partition contractor.

Please Contact Supawood on 1800 002 123 or if you have any questions, queries or suggestions.