Engineering Toolmaking (Mould, Tool and Die Equipment)

Engineering Toolmaking (Mould, Tool and Die Equipment)

Level 3

Awarded by the EMTA Awards Limited
Accredited from 2 November 2005to 30 November 2010
Group award number: G83C 23
Standards

This SVQ is based on standards developed by SEMTA. SEMTA draws its membership from the engineering sector.

For further information, please contact the SQA web site.

Structure of the SVQ

The way the SVQ is made up is shown below. The unit title appears in bold and the elements that make up each unit are listed under the unit title.

Mandatory units

Candidates must complete all of these units:

Complying with Statutory Regulations and Organisational Safety Requirements

1Complying with statutory regulations and organisational safety requirements

Using and Interpreting Engineering Drawings and Documentation

1Using and interpreting engineering drawings and documentation

Work Efficiently and Effectively in Engineering

1Work efficiently and effectively in engineering

Carrying Out Fault diagnosis on Mould, Press Tool or Die Equipment

1Carrying out fault diagnosis on mould , press tool or die equipment

Maintaining Mould, Press Tool or Die Equipment

1Maintaining mould, press tool or die equipment

Handing Over and Confirming the Completion of Mould, Press Tool or Die Equipment Maintenance Activities

1Handing over and confirming the completion of mould, press tool or die equipment maintenance activities

Optional units

Candidates must also complete 2 of the following units, in addition to the mandatory units.

Repairing or Modify Mould, Press Tool or Die Components

1Repairing or modify mould, press tool or die components

Producing Mould, Press Tool or Die Components by Manual Machining

1Producing mould, press tool or die components by manual machining

Preparing and Setting Power Presses

1Preparing and setting power presses

Carrying Out Condition Monitoring of Mould, Press Tool or Die Equipment

1Carrying out condition monitoring of mould, press tool or die equipment

Carrying Out Planned Maintenance on Mould, Press Tool or Die Equipment

1Carrying out planned maintenance on mould, press tool or die equipment

Carrying Out Planned Maintenance on Power Presses

1Carrying out planned maintenance on power presses

There may be publications available to support this SVQ. For more information, please contact:

EMTA Awards Ltd (EAL)

National Verification Centre

3365 Century Way

ThorpePark

Leeds

LS15 8ZB

Tel: 01132 601188

Fax:01132 321159

Website:

Engineering Toolmaking/3/140905/LK