CETOL GUPA
Quick drying woodfiller.
General
Main propertiesSingle-pack filler for small and quick repairs or filling of small holes
and clefts, and fast retouches of small imperfections.
It contains wood fibres, which provide the filler with
aesthetic and mechanical characteristics very similar to the
ones of wood itself.
It is recoatable with any kind of primer and enamel or with
clear topcoats.
UseRecommended for small works, fast repairs and retouches on
large surfaces too, but where a high thickness is not required.
Appropriate for exterior and interior use.
Application data
Application methodBy blade.
Air-dryingIt depends on the layer thickness and room temperature.
A layer thickness of 100 microns is dust-free in 4-5 minutes.
SandabilityAfter 1 hour at 20°C.
RecoatableAfter sanding, with solvent- or waterborne paints.
Properties
ColoursDark oak – Light oak – Mahogany – Meranti –
Merbau – Natural – Teak
Packaging750 ml – 150 ml
Specific gravity1,07 + 0,02 g/cm³
Total non-volatile54 + 1 % by weight
StorageTwo years at 20°C in well closed container
Instructions for use
Surface preparationThe substrate must be dry, clean and dust-free.
Clefts must be brushed in order to remove any dirt inside.
If possible, make the parts a little bit rough by sanding
them.
Remove rotten wood and treat bare partswith Sikkens Cetol HLS.
ApplicationLeave “head” to allow for slight shrinkage.
The product is ready for use and has to be applied by blade in
subsequent thin layers, in order to allow the solvents in the
previous layer to evaporate before the application of the next layer.
Avoid applying big quantities at the same time.
Store the can well closed in order to avoid a fast drying-process
of the product.
In case it is necessary to reduce the quantity of the product, use
cellulose thinner.
The present leaflet cancels and replaces any previous issue.02/99
Akzo Nobel Decorative Coatings - Export Department, B-1800 Vilvoorde