Material Safety Data Sheet Revision Date: 2009-06-09

I. PRODUCT AND COMPANY IDENTIFICATION

Product Name: / AMERIGUARD FIFTH WHEEL GREASE
Product Code: / AG-5THWHEEL-XX
Product Description / Base Oil and Additives
Intended Use: Grease
Emergency Phone: / (800) 233-4059 (202) 483-7616 (CHEMTREC)
Poison Control Center: / (800) 222-1222
Company: / SBP, Inc.
9915 SO. 148 ST.
Omaha, Ne 68138
Information Phone: / (800) 233-4059 (402) 895-2202
Revision Number: / 1

II. COMPOSITION/INFORMATION ON INGREDIENTS

Chemical Name / % / CAS # / OSHA Exposure Limits
ZINC DITHIOPHOSPHATE / <2.5% / 68649-42-3 / No PEL established

Components not listed are not physical or health hazards as defined in 29 CFR 1910.1200 (Hazard Communication Standard).

III. HAZARDS IDENTIFICATION

This material is not considered to be hazardous according to regulatory guidelines (see (M)SDS Section 15).

POTENTIAL HEALTH EFFECTS

Excessive exposure may result in eye, skin, or respiratory irritation. Low order of toxicity. High-pressure injection under skin may cause serious damage.

NFPA Hazard ID: / Health: 0 / Flammability: 1 / Reactivity: 0
HMIS Hazard ID: / Health: 0 / Flammability: 1 / Reactivity: 0

NOTE: This material should not be used for any other purpose than the intended use in Section 1 without expert advice. Health studies have shown that chemical exposure may cause potential human health risks which may vary from person to person.

0 - Least 1 - Slight 2 - Moderate 3 - High 4 - Extreme

IV. FIRST-AID MEASURES

Inhalation Irritation: / At ambient handling temperatures , no irritation due to inhalation is anticipated.
Skin Contact: / Wash contact areas with soap and water. If product is injected into or under the skin, seek immediate physician care regardless of the size of the entry wound.
Eye Contact: / Flush thoroughly with water. If irritation persists seek medical attention.
Ingestion Irritation: / Seek medical attention if discomfort occurs. .

V. FIRE FIGHTING MEASURES

Flammability Summary: / Not combustible/ not flammable.
Extinguishing Media: / Use water spray, foam, carbon dioxide, or dry chemical extinguishing agents. Water spray or fog may also be effective for extinguishing if swept across the base of the fire. Water can also be used to absorb heat and keep exposed material from being damaged by fire.
Fire and/or Explosion Hazards: / Material may be ignited only if preheated to temperatures above the high flash point, for example in a fire.
Fire Fighting Methods and Protection: / Do not enter fire area without proper protection including self- contained breathing apparatus and full protective equipment. Use methods for the surrounding fire.
Hazardous Combustion Products: / Aldehydes, Oxides of carbon, smoke, fumes, Sulfur oxides,Carbon dioxide, Carbon monoxide,

VI. ACCIDENTAL RELEASE MEASURES

Personal Precautions and Equipment: / No adverse health affects expected from the clean-up of spilled material. Follow personal protective equipment recommendations found in Section VIII of this MSDS.
Methods for Clean-up: / Prevent the spread of any spill to minimize harm to human health and the environment if safe to do so. Wear complete and proper personal protective equipment following the recommendation of Section VIII at a minimum. Dike with suitable absorbent material like granulated clay. Gather and store in a sealed container pending a waste disposal evaluation.

VII. HANDLING AND STORAGE

Handling Technical Measures and Precautions: / No special handling instructions due to toxicity.
Storage Technical Measures and Conditions: / Store in a cool dry ventilated location. Isolate from incompatible materials and conditions. Keep container(s) closed. Do not expose to extreme temperatures or flames.

VIII. EXPOSURE CONTROLS/PERSONAL PROTECTION

NOTE: Limits/standards shown for guidance only. Follow applicable regulations.

ENGINEERING CONTROLS

The level of protection and types of controls necessary will vary depending upon potential exposure conditions. Control measures to consider:

No special requirements under ordinary conditions of use and with adequate ventilation.

PERSONAL PROTECTION

Personal protective equipment selections vary based on potential exposure conditions such as applications, handling practices, concentration and ventilation. Information on the selection of protective equipment for use with this material, as provided below, is based upon intended, normal usage.

Respiratory Protection: If engineering controls do not maintain airborne contaminant concentrations at a level which is adequate to protect worker health, an approved respirator may be appropriate. Respirator selection, use, and maintenance must be in accordance with regulatory requirements, if applicable. Types of respirators to be considered for this material include:

No protection is ordinarily required under normal conditions of use and with adequate ventilation.

For high airborne concentrations, use an approved supplied-air respirator, operated in positive pressure mode. Supplied air respirators with an escape bottle may be appropriate when oxygen levels are inadequate, gas/vapor warning properties are poor, or if air purifying filter capacity/rating may be exceeded.

Hand Protection: Any specific glove information provided is based on published literature and glove manufacturer data. Work conditions can greatly effect glove durability; inspect and replace worn or damaged gloves. The types of gloves to be considered for this material include:

No protection is ordinarily required under normal conditions of use.

Eye Protection: If contact is likely, safety glasses with side shields are recommended.

Skin and Body Protection: Any specific clothing information provided is based on published literature or manufacturer data. The types of clothing to be considered for this material include:

No skin protection is ordinarily required under normal conditions of use. In accordance with good industrial hygiene practices, precautions should be taken to avoid skin contact.

Specific Hygiene Measures: Always observe good personal hygiene measures, such as washing after handling the material and before eating, drinking, and/or smoking. Routinely wash work clothing and protective equipment to remove contaminants. Discard contaminated clothing and footwear that cannot be cleaned. Practice good housekeeping.

ENVIRONMENTAL CONTROLS

See Sections 6, 7, 12, 13.

IX. PHYSICAL AND CHEMICAL PROPERTIES

Physical State: / Solid
Color: / Depends upon product selection
pH: / ND
Solubility in Water: / Negligible; 0-1%

X. STABILITY AND REACTIVITY

Stability: / Stable under normal conditions.
Conditions to Avoid: / Temperatures above the high flash point of this combustible material in combination with sparks, open flames, or other sources of ignition.
Materials to Avoid/Chemical Incompatibility: / Strong oxidizing agents
Hazardous Decomposition Products: / Carbon monoxide, sulfur oxides, aldehydes, and other petroleum decomposition products in the case of incomplete combustion. Oxides of nitrogen, phosphorus, calcium, copper, magnesium, sodium, and hydrogen sulfide may also be present.

XI. TOXICOLOGICAL INFORMATION

ACUTE TOXICITY

Route of Exposure / Conclusion / Remarks
Inhalation
Toxicity (Rat): LC50 > 5000 mg/m³ / Minimally Toxic. Based on assessment of the components.
Irritation: No end point data. / Not determined.
Ingestion
Toxicity (Rat): LD50 > 2000 mg/kg / Minimally Toxic. Based on test data for structurally similar materials.
Skin
Toxicity (Rabbit): LD50 > 2000 mg/kg / Minimally Toxic. Based on test data for structurally similar materials.
Irritation (Rabbit): Data available. / Negligible irritation to skin at ambient temperatures. Based on assessment of the components.
Eye
Irritation (Rabbit): Data available. / May cause mild, short-lasting discomfort to eyes. Based on assessment of the components.

CHRONIC/OTHER EFFECTS

Contains:

Base oil severely refined: Not carcinogenic in animal studies. Representative material passes IP-346, Modified Ames test, and/or other screening tests. Dermal and inhalation studies showed minimal effects; lung non-specific infiltration of immune cells, oil deposition and minimal granuloma formation. Not sensitizing in test animals.

Additional information is available by request.

The following ingredients are cited on the lists below: None.

--REGULATORY LISTS SEARCHED--
1 = NTP CARC / 3 = IARC 1 / 5 = IARC 2B
2 = NTP SUS / 4 = IARC 2A / 6 = OSHA CARC

XII. ECOLOGICAL INFORMATION

Overview: / Moderate ecological hazard. This product may be dangerous to plants and/or wildlife.
Mobility: / No data
Persistence: / No data
Bioaccumulation: / No data
Degradability: / No data
Ecological Toxicity Data: / 0

XIII. DISPOSAL CONSIDERATIONS

Disposal of Packaging: / Recycle containers whenever possible.
Disposal Methods: / Dispose of according to Federal, State, Local, or Provincial regulations.

XIV. TRANSPORTATION INFORMATION

DOT & IMDG: NOT RESTRICTED

XV. REGULATORY INFORMATION

SARA (311/312) REPORTABLE HAZARD CATEGORIES: None.
SARA (313) TOXIC RELEASE INVENTORY:
Chemical Name / CAS Number / Typical Value
ZINC DITHIOPHOSPHATE / 68649-42-3 / < 2.5%
TSCA Status: A component or components of this product are listed on the TSCA Inventory of Existing Chemical Substances. / .

The Following Ingredients are Cited on the Lists Below:

Chemical Name / CAS Number / List Citations
DIPHENYLAMINE / 122-39-4 / 5, 9, 18
PHOSPHORUS / 7723-14-0 / 1, 4
ZINC DITHIOPHOSPHATE / 68649-42-3 / 13, 15, 17
--REGULATORY LISTS SEARCHED--
1 = ACGIH ALL / 6 = TSCA 5a2 / 11 = CA P65 REPRO / 16 = MN RTK
2 = ACGIH A1 / 7 = TSCA 5e / 12 = CA RTK / 17 = NJ RTK
3 = ACGIH A2 / 8 = TSCA 6 / 13 = IL RTK / 18 = PA RTK
4 = OSHA Z / 9 = TSCA 12b / 14 = LA RTK / 19 = RI RTK
5 = TSCA 4 / 10 = CA P65 CARC / 15 = MI 293

XVI. ADDITIONAL INFORMATION

Disclaimer: / This material safety data sheet and the information it contains is offered to you in good faith as accurate. We have reviewed any information contained in the data sheet which we have received from outside sources and we believe the information to be correct, but cannot guarantee its accuracy or completeness. Health and safety precautions in this data sheet may not be adequate for all individuals and/or situations. It is the user's obligation to evaluate and use this product in a safe manner and to comply with all applicable laws and regulations. No statement made in this data sheet shall be construed as permission or recommendation for the use of any product in a manner that might infringe existing patents. No warranty is made, either expressed or implied.

AMERIGUARD FIFTH WHEEL GREASEPage 1 of 5