Please read this manual fully before installation.

Ensure all safety procedures are followed and adequate care is taken during installation.

If in doubt about any aspect please consult a qualified electrician.

This AC220V 1 channel wireless remote control operates in433MHz frequency. It works with latched mode. Just press slightly the buttons on the remote; you can control universal electrical devices. Control lights, motors, fans, electrically operated doors / locks / windows / blinds / cars or other appliances.

Features:

·Wireless control, easy to install

·Control Lights, Motors, Fans, electrically operated Doors/Locks/Windows/Blinds/Cars or Other Appliances with AC180~250V.

·You can turn on/off the receiver with transmitter (remote control) from any place within a reliable distance; the wireless RF signal can pass through walls, floors and doors.

·This switch can learn different coding remote controls (such as 2262,1527ect.)

·One/several transmitters can control one/several receivers simultaneously.

·If you use two or more receivers in the same place, you can set them with different codes. If you use multi-button transmitter, you can control the controller with different buttons, they won’t affect each other.

·Transmitting Frequency: 433MHz

·The wireless receiving controller, with high confidentiality, stable performance, low power consumption characteristic, jump line or dial the code switch coding.

Receiver:

·Channel: 1 CH

·Coding Type: learning code

·Power Supply (Operating Voltage): AC180~250V

·Maximum Working Current: 30A

·Output Mode: Without voltage output (switching output), or input AC220V then output AC220V (direct output) adjustable by soldering different dot on the back of the receiver (see photos below).

Control type:Momentary Toggle Latched adjusted by the Jumper on the Receiver

Momentary------Take away the Jumper or put the Jumper on 1 pin.

Toggle------Put the Jumper on “1&2” Pin

Latched------Put the Jumper on “2&3” Pin

Momentary------Press the Transmitter button and keep, the receiver relay is ON, release button, the receiver relay is OFF,

Toggle------Press transmitter button for 1 time, the receiver relay is ON, press button again, the receiver relay is OFF,

Latched------Press transmitter button A, the receiver relay A is ON, Press Button B, the Receiver is OFF

Learning Code

  1. press the learning button on the receiver .the indicator will flash,release your finger, press any button of the transmitter,the indicator flash 2 times and off, meaning learning procedure has been sucessful.

Clear the Code

  1. Press the learning button about 8 seconds, the indicator turn on to off , it means the information that you keep have been removed successfully .

3. It can learn more than 12 PCS 2262 or 1527 chip with the different code wireless remote control

Wiring diagrams

  1. Direct output wiring

  1. Switching output wiring

Please note: For the 2 different wiring diagrams, the back of the receiver board connection is different. Before connecting an appliance please ensure you have the correct output type to avoid any potential damage to equipment (see photos below)

  1. Direct_output
  2. Switching output

FAQs
Q Why is there no voltage output from the switch?
A There is no voltage output, the switch acts as a connecter or disconnecter for an existing live circuit.
Q Why is there no response from the switch when the remote is pressed?
A First try clearing the remote by holding down the learning button until the led light flashes, then add the remote again. If this doesn't work try changing the battery in the remote.
Q How do I extend the range?
A This is possible by ensuring there are no obstacles, the remote has a good battery and the receiver a good power supply. Also the receiver aerial can be gently extended.