1. Installation Guide

1.  Installation guide

Pine define：

Red—VDD （5V～12V）

Black—GND

Yellow—TX

White—RX

USB Adaptor

Computer

Receiver module

2.Operation：

Start the software（TPMS.exe）As the picture below。

Learning SENSOR ID：

Press going to setting mode，as shown：

Press learning mode to set SENSOR ID icon，as shown：

Under this icon， let 4 pcs of SENSOR to transmit data and complete the identify after setting press the Learn ID to exit。Afterward the SENSOR can function normal。

TYREDOG RF MODULE UART PROTOCOL

UART TYPE: 9600,8,N,1

1: GET WHEEL DATA:

A:GET FL WHEEL: COMPUTER -->MODULE : "$W0#" , 4 BYTE

B:GET FR WHEEL: COMPUTER -->MODULE : "$W1#" , 4 BYTE

C:GET RL WHEEL: COMPUTER -->MODULE : "$W2#" , 4 BYTE

D:GET RR WHEEL: COMPUTER -->MODULE : "$W3#" , 4 BYTE

If success

MODULE-->COMPUTER "$WBRHPPTTCC#" 12 BYTE

W: wheel position

W=0 :FL front left

W=1 :FR front right

W=2 :RL rear left

W=3 :RR rear right

B:BATTERY INDICATION

B= 0 : normal

B= 1 : battery low power

R: WHEEL DATA UPDATE INDICATION

R= 0: data is not updated

R= 1: data is updated

H: tire pressure

H=5: 0.5PSI

H=0: 0.0PSI

PP: tire pressure (unit=1 psi)

If PP=0xFF the data is error or not ready

TT: tire temperature ,0-185 ó -40-145 degree C

If TT=0xFF the data is error or not ready

CC:chksum

Example

“$2015435296#”

CC=ASCII ( 2+0+1+5+4+3+5+2 )

=0x32+0x30+0x31+0x35+0x34+0x33+0x35+0x32

= 0x196

Wheel position =:RL( rear left);

Battery power is normal

Data is updated

Pressure = 67.5 psi

Temperature = 0x52 =82=42 degree C ( Reading 0 -40℃)

2: ENTER LEARN ID MODE

COMPUTER -->MODULE : "$LEARN#" , 7 BYTE

IF SUCCESS, MODULE -->COMPUTER : "$LEARN#" , 7 BYTE

3: EXIT LEARN ID MODE , TEST MODE OR SLEEP MODE

COMPUTER -->MODULE : "$LEND#" , 6 BYTE

IF SUCCESS, MODULE -->COMPUTER : "$LEND#" , 6 BYTE

4: SET AUTO /MANU TX

SET AUTO TX COMPUTER -->MODULE : "$T0#" , 4 BYTE

SET MANU TX COMPUTER -->MODULE : "$T1#" , 4 BYTE

5: ENTER TEST MODE

COMPUTER -->MODULE : "$TEST#" , 6 BYTE

IF SUCCESS, MODULE -->COMPUTER : "$ TEST #" , 6 BYTE

6: IN TEST MODE

RECEIVE ANY TEST RF CODE

MODULE --> COMPUTER : "$TESTRF #" , 8 BYTE

7: ENTER SLEEP MODE

COMPUTER --> MODULE : "$SLEEP#" , 7 BYTE

IF SUCCESS, MODULE --> COMPUTER : "$SLEEP#" , 7 BYTE