Paper Title 1
WITH HIGH SPEED MACHINING TOWARDS 21st CENTURY
Roko Cebalo
Herbert Schulz
Toma Udiljak
Prof.dr.sc. R. Cebalo, University of Zagreb, FSB, I. Lucica 5, 10000 Zagreb
Prof.Dr.-lng. H. Schulz, PTW Institute, TU-Darmstadt, Petersenstr. 10, 64287 Darmstadt
Dr.sc. T. Udiljak, University of Zagreb, FSB, I. Lucica 5, 10000 Zagreb
Keywords: high speed machining, high dynamic machine tools,
hard machinable materials
ABSTRACT
The great expectations for further improvement of manufacturing engineering, at the transaction to the 21st century, in the area of the machining systems are laid down into high speed machining....
1. INTRODUCTION
Yet in the 90-ties, by applying ever harder and more wear and temperature resistant cutting materials, started investigations of machining processes with the objective to increase cutting speeds. It illustrates the way cutting materials influence development of machining processes and machine tools. Taylor's assumption that cutting temperature rise with increase of cutting speed was worthy before finding of high speed machining (Carl Salamon, 1931), figure 1. ...
.
.
.
X. LITERATURE
1.R. Cebalo; H. Schulz; T. Udiljak : With high speed machining towards 21st century,
4th International Conference on Production Engineering CIM'97, Zagreb 1997.
INSTRUCTIONS FOR WRITING THE PAPER
File: Microsoft Word .
Please, take care that your document have more than 5 pages, including firs page.
All figures and tables should be saved with document and safely positioned on their places in the printed form of the document, and named accordingly to its position in the text.
DOCUMENT FORMATTING
Paper size : A4 (21 x 29,7 cm)
Margins: Up 3 cm (4 cm for the first page)
Down 3 cm (4 cm for the first page)
Left 3 cm
Right 2.5 cm
Mirror margins ; different first page (without header); different odd and even pages
Even pages (pages 2, 4, 6, 8, ... ):header Left side - page number
Right side - authors name
Odd page (3, 5, 7, 9,...):headerLeft side -paper title
Right side - page number
STYLE INSTRUCTIONS
Heading 1: PAPER TITLE (Arial, 14 pt. bold, Capital letters, Alignment Center )
Authors name below Title : (Arial, 11 pt. , AlignmentCenter )
Authors name and adress : (Arial, 11 pt. , AlignmentCenter )
Heading 2 : Keywords: , ABSTRACT , 1. INTRODUCTION ...(Arial, 11 pt. bold, Alignment Left) like in sample
Text style : (Arial, 11 pt. first line indented 1.25 cm, line spacing 16 pt. , Alignment Justify)
Figure text Style : (Arial, 11 pt. italic, AlignmentCenter)
Literature numbering style : ( Arial, 11 pt.) , like in sample below
1. R. Cebalo; H. Schulz; T. Udiljak : With high speed machining towards 21st century,
4th International Conference on Production Engineering CIM'97, Zagreb 1997.
Remark :
For possible questions considering paper writing contact organizers or e-mail on address:
or