TVS Endurance Race Rules
RACE PROCEDURE:RACE WILL CONSIST OF 12 MINUTE HEATS. ROUND ROBIN FORMAT WILL NOT BE USED.
IF MORE THAN (8) RACERS ARE ENTERED, MULTIPLE MAINS WILL BE HELD AND OVERALL
RESULTS WILL BE MERGED TO DETERMINE FINAL STANDINGS. EACH MAIN MUST
CONTAIN A MINIMUM OF (5) RACERS. A RACER’S GUARANTEED STATUS WILL BE
PROVIDED AT TIME OF ENTRY. YOU WILL KNOW IF YOU ARE GUARANTEED
BEFORE YOU TRAVEL TO THE TRACK
AVAILABLE SPOTS WILL BE DETERMINED ON A FIRST COME/FIRST SERVE BASIS. ENTRY
IS ONLY CONFIRMED ONCE ENTRY FEE IS PAID. PRE-ENTRY IS PERMITTED TO SECURE
A STARTING SPOT
ONCE RACING BEGINS, ALL PIT BOXES MUST BE CLOSED.
EACH RACER WILL BE PROVIDED A DESIGNATED PIT AREA IN WHICH ALL SPARE PARTS
AND TOOLS MUST BE LOCATED. ONCE RACING BEGINS, ONLY THE ITEMS WITHIN A
RACER’S DESIGNATED PIT AREA MAY BE USED
ONE HANDOUT MOTOR WILL BE INCLUDED WITH $25 ENTRY FEE. ADDITIONAL MOTORS
MAY BE PURCHASED FOR $11.95
MUST COMPLETE ENTIRE RACE WITH THE SAME BODY, CHASSIS AND DRIVER
MID-RACE “QUICK TECHS” MAY BE PERFORMED AT ANY TIME TO ENSURE PROPER
CHASSIS CLEARANCE, MIN TIRE DIAMETER, AXLE WIDTH, CHASSIS AND MOTOR ETC..
ANY CARS THAT FAIL “QUICK TECHS” MUST BE REPAIRED UNDER GREEN
1. CHASSIS:
MUST USE 4.5” WB STAMPED FCR CHASSIS.
NO MODIFICATIONS TO CHASSIS PERMITTED
ANY GUIDE FLAG MAY BE USED
BRACING MAY BE ADDED
MIN CHASSIS GROUND CLEARANCE: .062” (AT ALL LOCATIONS)
CHASSIS CLEARANCE MUST BE MAINTAINED AT ALL TIMES. PERIODIC CLEARANCE
CHECKS WILL BE PERFORMED. IF YOUR CARS FAILS TO MEET REQUIREMENTS, IT MUST
BE REPAIRED UNDER GREEN FLAG CONDITIONS AND WILL NOT BE ALLOWED TO RETURN
TO RACING UNTIL TECH IS PASSED.
2. MOTOR:
MUST USE TSR HANDOUT MOTOR ONLY. ONE MOTOR WILL BE INCLUDED WITH ENTRY
FEE. ADDITIONAL MOTORS MAY BE PURCHASED.
ANY LEAD WIRE MAY BE USED. CLIPS PERMITTED
3. AXLE:
MUST USE 1/8 AXLE. OILITES ONLY, NO BEARINGS
3.25” MAX WIDTH FRONT & REAR. EQUALLY SPACED ON BOTH SIDES.
WHEN MEASURING WIDTH, CAR MUST FALL FROM TECH GAUGE WITH ITS OWN WEIGHT.
4. GEARS:
ANY 48P PINION AND CROWN GEAR MAY BE USED
5. TIRES:
MUST USE THE FOLLOWING TIRES ONLY
FRONT: ANY FRONT TIRE THAT MEETS SPECS LISTED BELOW
REAR: JK PART #T13L8 OR T13L8T
MIN DIAM: REAR: .840 FRONT: .810
MIN WIDTH: FRONT: .400
MAX WIDTH: REAR: .810
6. BODY:
MUST USE LEXAN NASCAR BODY MIN .010” THICK
MIN ROOF HEIGHT: 1 7/8”. MAY NOT BE "BUBBLED" TO PASS TECH.
FRONT BUMPER TO BE CUT ON THE CUT LINE. 1/8" MIN REAR BUMPER HEIGHT.
REAR SPOILER MAY NOT BE HIGHER THAN 1 3/4
NO ADDED SPOILERS
MUST HAVE VISIBLE NUMBERS ON BOTH DOORS
MUST HAVE FULL 3-D INTERIOR SUCH AS PARMA #807 OR CHAMPION #361-C
NO DROOPING OF INTERIOR.
ALL MEASUREMENTS TAKEN MUST MEET REQUIREMENTS USING TVS TECH TOOLS
IF IT DOESN'T SAY YOU CAN DO IT, YOU CAN'T!