WMP-225
Professional Portable Wireless Microphone System
VHF Wireless Headset & Lapel Microphone
Owner’s Manual
A) INTRODUCTION
Congratulations on your purchase of the Pure Acoustics WMP-225 Professional Portable Wireless MIC system. Pure wireless microphones are equipped with the latest technology that provides wireless solutions for any device equipped with a MIC input port. Additionally, the dedicated frequency band prevents unwanted interference caused by electronic devices in the vicinity (i.e. CD, DVD and BluRay players, Hi Fi audio equipment, etc…).
l High FM band use to minimize frequency interference
l Powered by 1.5V AA alkaline battery to enable extended use even at low battery conditions.
l Multi level high and mid frequency narrowband filter to negate any possible interfering signals.
l All quartz crystal oscillating circuits to ensure steady frequencies during use
l Separate channels for down sampling and mix sampling for public addressing and karaoke use.
l Propriety noise detection and cancellation technology that mutes unwanted background sound
l Excellent chipsets and components assure consistent wireless microphone performance.
B) SETTING UP THE MICROPHONE (TRANSMITTER) AND RECEIVER
1. Open the transmitter battery cover (4) and insert the 9V AA battery following the indicated correct polarity and slide close the cover until an audible click is heard.
2. Insert the Micro connector (5) into the Transmitter socket (1).
3. Open the Receiver battery cover and insert two (2pcs) size AAA batteries following the indicated correct polarity and slide close the cover until an audible click.
4. Insert the 6.35mm end of the receiver output jack (9) into the socket of your amplifier.
5. Set both Transmitter power switch (2) and Receiver power switch (7) to the ON position. The Receiver pilot LED (8) will illuminate.
6. At this point, the Transmitter signal LED (3) and the Receiver signal LED (8) should be illuminated, indicating a good connection has been established and is ready for use.
PRECAUTIONS:
1. If acoustic quality and volume are abnormal or receiving distance shortens, the batteries in the transmitter and/or receiver needs to be replaced.
2. If your microphone is not to be used for an extended period of time, it is advisable to remove the batteries on both transmitter and receiver prior to storage to avoid damage to the unit due to battery leaks.
3. If the microphone is too close to the audio output speakers or the volume of the amplifier is too high, feedback may occur and may damage the speaker or amplifier. In this case, please keep the microphone in an appropriate distance from the speaker or have th volume of the amplifier turned down to a safe level to avoid feedback.
C) WMP-225 Technical Specifications:
Receiver:
Carrier Frequency: 202.25MHz
Frequency Response: 50Hz-15kHz ±3dB
Power Supply and Voltage: 1.5V AA Alkaline batteries
Power Consumption: 4W
Transmitter:
Transmit Power: 10mW
Modulation Mode: FM
Power Supply and Voltage: 9V battery