1. To begin a cornering angle check. Technician A turnsthe left front wheel out 20 degrees. Technician Bsays that at this point the readings on the right wheelshould read about 2 degrees more than the left.Who is correct?

A. Technician A

B. Technician B

C. Both A and B

D. Neither A or B

  1. In unibody construction, what provides the critical mounting positions for the suspension and steering systems?

A. Body panels

B. Drivetrain

C. Upper and lower control arms

D. Cradle assembly mounting biscuits

  1. After examining a collapsed steering column TechnicianA attempts to repair the collapsed portion. TechnicianB says that to remove the steering wheel youmay need to use a wheel puller. Who is correct?

A. Technician A

B. Technician B

C. Both A and B

D. Neither A or B

  1. What is the definition of camber?

A. The forward or backward tilt of the steering axis

B. The distance between the centerline of the balljoints and the centerline of the tire at the pointwhere the tire contacts the road surface

C. The amount of toe-out present on turns

D. The inward or outward tilt of the tire as measuredat the top

  1. To determine whether an improper toe condition iscaused by poor wheel alignment or damaged suspensioncomponents, Technician A makes a corneringangle check; Technician B makes a jounce/rebound check. Who is correct?

A. Technician A

B. Technician B

C. Both A and B

D. Neither A nor B

  1. Which of the following statements concerning brake systems is incorrect?

A. All cars are now required to have two hydraulic systems.

B. The major brake component that a technician must repair is the brake line.

C. A hose that is blistered does not necessarily have to be replaced.

D. The wheel cylinder converts hydraulic pressure to mechanical force.

  1. Which emission control subsystem is responsible for channeling blowby gases into the fuel intake area?

A. Engine control

B. Positive crankcase ventilation

C. Evaporative

D. Exhaust gas recirculation

  1. After recovering the refrigerant from an A/C system, Technician A uses plastic wrap with wire ties to keep moisture out of the components of the system.Technician B replaces the receiver-drier if the systemhas been open to the atmosphere for severaldays. Who is correct?

A. Technician A

B. Technician B

C. Both A and B

D. Neither A or B

  1. Explain the difference between voltage, current, and resistance.

______

  1. Describe the three functions of a vehicle's suspension system.

______

TTTE Mechanical Components Test

AUTO COLLISION DEPT …excellence through effort