Handreader Enrollment Process

Handreader Enrollment Process

From the handreader idle prompt

Press the Clear and Enter button

The screen should now look like this

Press the number 4 and then press Enter.

The screen should now look like this

Select Yes to add an employee or select No to move to the next menu option

Adding an Employee

After selecting Yes to add an employee you should see this screen.

Enter the number that the employee will use each time to identify him/her at the handreader and press Enter. The enrollment process will then begin.

The screen should now look like this

Have the employee place their hand on the platen with their palm flat and their fingers touching the finger pegs, once the reader is able to take a measurement, it will prompt the employee to remove their hand

The employee will be prompted to place and remove their hand 2 more times to get an average of the measurements taken, upon successful enrollment the screen will look like this

The enrollment is now complete for this employee and you will now be back to the Add Employee screen; press the Yes # key to enroll another employee or the Clear button to leave the enrollment screen.

Adding a Supervisor

Once you have added your employees, it’s a good idea to add a couple of supervisors to the reader, these individuals will be responsible for adding and removing employees and once added, restrict regular employees from going into the system menus and changing settings or removing employees.

At the Add Employee screen press No

you should now be at the Add Supervisor screen

use the same steps used to add a supervisor as you did to add an employee, when you are finished adding supervisors, press the clear button at the add supervisor screen to go to the main menu.

Once supervisors are enrolled, only a supervisor can gain access to the reader setup and enrollment menus.

Supervisor Access to Reader

From the handreader idle prompt

Press the Clear and Enter button

The screen should now look like this

Enter your supervisor number and press Enter, you will be prompted to scan your hand once, now the screen will ask you for the desired password.