ISY994 Z Series TZB45 Conifguration Guide

ISY 994 Z Series

RCS Thermostat Configuration Guide

supporting

TZB45

Based on firmware 4.0.5+

Universal Devices, Inc.

Page - 1 -

ISY994 Z Series TZB45 Conifguration Guide

Table of Contents

0.0 Revision History

1.Introduction

2.ISY Installation

3.Configuring Zigbee Network

4.Configure the Thermostat

0.0 Revision History

Date/Firmware / Type / Change / Description
2014/2/10
4.1.2 / DOC / Initial / Initial release
  1. Introduction

ISY994 Z Series incorporates sophisticated energy management capabilities to the base ISY platform supporting Zigbee RCS Thermostats. As such, all ISY interfaces, services, and events are applicable to 994Z as well. In addition, ISY994 Z series comes equipped with an integrated high powered Zigbee radio operating on a Zigbee PRO stack.

Upon startup, ISY either establishes a PAN (as a Coordinator) or starts operating on the PAN that was already established prior to reboot. It’s quite important to make sure that thermostats are searching and joining the correct PAN and sending events to the correct end point. As such, there are two phases for the correct operation of the system:

  1. Setup ISY for a specific PAN ID and channel mask that is known not to interfere with other RF devices such as WiFi systems
  2. Configure the thermostats to join the PAN

Upon successful configuration, the thermostats automatically scan and join the PAN and starts publishing energy events.

ISY994 Series is based on the same framework as ISY and therefore communications and event infrastructure follow the same paradigm.

ISY994 Z Series comes equipped with the energy monitoring module (MOD21011) as well as RCS Zigbee Thermostat Module (MOD22000). If you have ISY994 Series, you will need to purchase these modules through the Admin Console | Help | Purchase Modules.

  1. ISY Installation

a)Connect one of the included Cat5e cable to ISY’s Network Port and to your network hub. Note: the network must initiallybe DHCP enabled.

b)[Optional for ISY994i Series] Connect the second included Cat5e cable to ISY’s Port A and the other end to the PLM

Note: If your PLM is model number 2413S, you do need a power supply (not included)

c)If you do not have Java installed, please install the latest for your platform. You may find the latest Java downloads at . Please choose the latest JRE for your platform

d)Follow these instructions to install ISY Finder/Launcher app (Figure 1) on your desktop which should be used here on out. Click on your ISY on the list which brings up the launch menu

  1. Click on the Dashboard menu item to perform the rest of the setup in this document
  2. In either case, when prompted to authenticate, enter admin for both username and password
  3. In case you wish to add/configure INSTEON/Z-Wave devices or perform more advanced programming, from the same menu, choose the Admin Console

Figure 1 – ISY Finder/Launcher

  1. Configuring Zigbee Network

Setup Zigbee network as depicted in Figure 3a and 3b below.

Figure 3a – Zigbee Menu

Figure 3b – Zigbee Settings

Note: If you are also trying to communicate with Brultech Energy Monitors (ECM1240 or GEM), make sure you click on the Compatibility button otherwise ECM may not find ISY.

  1. Configure the Thermostat

Please consult the attached TZB45 Setup Guide. Zigbee configuration is outlined on page 16.

Universal Devices, Inc.

Page - 1 -