10th International Symposium
„Topical Problems in the Field of Electrical and Power Engineering“
Pärnu, Estonia, January10-15, 2011Heading 3, center
How to make the layout of a paperto be published in the Heading 1 TimesNR Bold 14pt Proceedings
Rain Lahtmets
TallinnUniversity of Technology
1
Abstract Heading 2
The proceedings will be produced directly from the manuscripts on A4-size paper without reducing. This page is made according to these instructions and serves as a model manuscript (except comment-boxes).
It is recommended that the length of the manuscript should not exceed 4…6 pages.
These instructions are for guidance of the author writing the final manuscript. They have been written assuming that you are a Word-user. If you use Linux or other programs, please, pay attention that your manuscript will look as similar as possible.
KeywordsHeading 2
Page setup, font, layout, e-mail address
IntroductionHeading 2
The manuscript shall be printed on one-sided sheets of A4-size paper.
1 Page setupHeading 2
Margins
- Top 2 cm
- Bottom2 cm
- Inside3,5 cm
- Outside2 cm
Mirror margins
2 Text layoutHeading 2
2.1 Format paragraph Heading 3
AlignmentJustified
Indentation0 cm
Spacing:
Before0 pt
After6 pt
Line spacingsingle
2.2 Columns Heading 3
In our proceedings we have two columns. Please, set the spacing 0,5 cm. Then the column width will be 7,5 cm.
If you have figures or tables that are wider than 7,5cm, the width of the whole page can be used. Example:
1
Table 1. Recommendations
Normal text / Heading 1 / Heading 2 / Heading 3 / EquationsFormat/
Font / Times New Roman / 10 pt / Bold, 14 pt / Bold, 12 pt / Bold, 10 pt / MS Equation
Format/
Paragraph / Alignment / Justified / Center / Left / Left / Left
Spacing before / 0 pt / 12 pt / 6 pt / 0 pt / 0 pt
Spacing after / 6 pt / 6 pt / 6 pt / 6 pt / 6 pt
Fig. 1. The figure may have the whole page width as text example for figure
1
2.3 Equations and unitsHeading 3
Equations shall be preceded as text with spacing after 6 pt. The equation number, if it needs, within parentheses, should be in line with the right hand margin. The parameters in the equations should be explained in the text itself or in a nomenclature list following the abstract.
(1)
The international system of units (SI) should be used throughout. If other units are used, the corresponding conversion must be included.
ReferencesHeading 2
1. Åvall, Å., Hietanen, S., and Auerkari, P. Instructions for preparing a manuscript for Baltica II, 1992. 7 p. (Unpublished document).
Please send your paper as attachment
to mailbox
1