TECHNICAL INFORMATION (TDS 51)

ENSURE © 46
DESCRIPTION / Modified CA with Low Odour/Low Fume/Low Bloom Characteristics. Medium Viscosity 50 cps.
Ensure© grades exhibit typical qualities across the range of viscosities we produce. The main benefits are of Low Odour and performance on plastics and other materials is enhanced by the “No Bloom” characteristics found in using this product. Three grades are available, Ensure© 43 is High Viscosity - 1500cps, Ensure© 46 is Standard - 50cps, Ensure © 48 us Low Viscosity - 3/10 cps.
APPLICATIONS
All bonds where no bloom is essential for cosmetic finish. The added benefit of Low Odour makes bonding in confined areas or on textiles such as used in Lampshade manufacture more user friendly. Performance speeds are slower giving time for alignments.
USEFUL HINTS/NOTES
Use Ensure© with tab tips to obtain controlled flow. The use of proper Barrier Cream is advised.
PROPERTIES
Steel to Steel:…………………….22 N/mm(2)
Rubber to Rubber ……..:………..10 N/mm(2)*
Plastic to Plastic …………………16 N/mm(2)*
*Substrate failure, not adhesive.
INSTRUCTIONS FOR USE
Ensure parts are clean, dry and free from oil and grease.
PROCEDURE FOR APPLICATION
Apply sparingly to one side and hold parts until handling strength is achieved.
COMPATIBLE ACCELERATORS/PRIMERS
Primers such as 7A02 or Double Strength 7A11 as accelerators for fillet cure for priming absorbent surfaces. / TECHNICAL FEATURES
Resin…………………………………….Modified CA
Colour…………………………………..Clear
Cure Speed With Activator……….…….<5 seconds
Cure Speed Without Activator………… 15-30 seconds
Viscosity….……………………………..50cps
Gap Fill…………………………………..0.1mm
Flash Point……………………………….>85°C
Shelf Life…………………………………>6 months @ 20°C
Specific Gravity…………………………1.06
Max. Operating Temperature………….. + 80°C
CURED PERFORMANCE
Fixture Time:……………………………<30 seconds
Strength:…………………………………Max 22 N/mm(2)
STORAGE
Store in a cool area out of direct sunlight. Refrigeration to 5C gives optimum storage stability.
PRESENTATION
Bottles:…………………………………..20g, 50g, 500g
HEALTH & SAFETY IN USE
DANGER -Superglue bonds skin and eyes in seconds.
If accidental skin bonding happens wash with warm soapy water and prise skin apart using a blunt instrument (such as a teaspoon handle).
In case of eye contact, bathe immediately with water and seek immediate medical attention.
The information contained herein is produced in good faith and is believed to be reliable but is for guidance only. Holdtite and its agents cannot assume liability or responsibility for results obtained in the use of its products by persons whose methods are outside or beyond our control. It is the users responsibility to determine the suitability of any of the products and methods of use or preparation prior to use mentioned in out literature and furthermore the users responsibility to observe and adopt such precautions as may be advisable for the protection of personnel and property in the handling and use of any of our products.