1.Table of Contents

1.Table of Contents

2.Introduction

3.Operation

4.Power Supply

5.Polar Patterns

6.Schematics

7.Warranty

8.REGISTRATION

2.Introduction

Thank you for purchasing the Cathedral Pipe’s model Stephansdom ( St. Steven’s Cathedral). The Stephansdom is modeled after the famous C12 by Austrian microphone manufacturer AKG. It is guaranteed to reproduce you source material with the utmost transparency retaining clarity and the quality you expect. You have made an excellent decision in choosing such a superior microphone and will not be disappointed. Please send us your comments, as we would love to hear your feedback.

3.Operation

Connect the 7pin cable (supplied with microphone) between power supply and microphone. Audio comes from the additional 3pin XLR on the power supply. If possible use a short cable and a high quality microphone preamplifier (with the phantom power turned off). This is of course best for audio quality. Try to avoid running the microphone signal thru a patch bay or extra connectors and wires. Attach the microphone securely to a good stand and lay the cables so that people cannot trip over the cable or topple the stand. Connect the power supply to the wall outlet and turn on the supply. Let the microphone warm up for at least 5 minutes before using. If the 7 pin, power, or XLR connectors become loose over time, make sure to tighten them with a screw driver.

4.Power Supply

A)XLR output

B)7pin microphone connection

C)Pattern Selector

D)110/230 voltage section (WARNING!! Only use 110 in North America)

E)IEC power cable connector

F)Illuminated On/Off switch

5.Polar Patterns

There are 3 main polar patterns used with most microphones today they are :

Omni CardioidFigure Eight

This model will allow you to not only choose between these patterns but it also has available the in between patterns. With this flexibility you will be able to dial in the sound you want. For example, a setting between the cardioid and figure eight will result in super-cardiod and hyper-cardiod patterns as shown below.

When using your Cathedral Pipe for close microphone applications such as vocals or solo instruments you can use the different polar patterns to adjust the proximity effect. By adjusting pattern selection switch you can dial in the amount proximity effect for this particular use. More Omni will give less proximity effect while more figure eight will bring in more lows. In other words, amongst other uses, the pattern select can be an effective bass control.

6.Schematics

Please Note! These schematics are provided for the owner’s education only. Please see the Warranty and read it carefully before attempting any repairs or modifications. These schematics are the intellectual property of Cathedral Pipes. We ask that you do not post it on the Internet or distribute it. If you want to use them to make your own versions then we invite you to go for it. Good luck.

7.Warranty

All Cathedral Pipe equipment is covered by a limited warranty against defects in materials and workmanship for a period of 90 days from date of purchase to the original purchaser only. A further optional limited 5-year warranty is available to the original purchaser upon proper registration of ownership within 30 days of date of first purchase.

Proper registration is made by filling out and returning to the factory the warranty card attached to this general warranty statement, along with a copy of the original sales receipt as proof of the original date of purchase. Only 1 card is issued with each unit, and the serial number is already recorded on it.

If the warranty registration card has already been removed then this is not a new unit, and is therefore not warranted by the factory. If you believe this to be a new unit then please contact the factory with the details of purchase.

Under the terms of the warranty defective parts will be repaired or replaced without charge, excepting the cost of tubes. No warranty is offered on tubes period.

If a Cathedral Pipes product fails to meet the above warranty, then the purchaser's sole remedy shall be to return the product to Cathedral Pipes, where the defect will be repaired without charge for parts and labor. The product will then be returned via prepaid, insured freight, method and carrier to be determined solely by Cathedral Pipes. All returns to the factory must be in the original packing, (new packing will be supplied for no charge if needed), accompanied by a written description of the defect, and must be shipped to Cathedral Pipes via insured freight at the customer's own expense. Charges for unauthorized service and transportation costs are not reimbursable under this warranty, and all warrantees, express or implied, become null and void where the product has been damaged by misuse, accident, neglect, modification, tampering or unauthorized alteration by anyone other than Cathedral Pipes. The warrantor assumes no liability for property damage or any other incidental or consequential damage whatsoever which may result from failure of this product. Any and all warrantees of merchantability and fitness implied by law are limited to the duration of the expressed warranty.

All warrantees apply only to Cathedral Pipes products purchased and used in the USA. Some states do not allow limitations on how long an implied warranty lasts, so the above limitations may not apply to you. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above exclusion may not apply to you. This warranty gives you specific legal rights and you may also have other rights, which vary from state to state.

8.REGISTRATION

We ask that you please fill out this registration form and send the bottom half to:

Cathedral Pipes

305 Bellcour Way

Lake Forest CA 92630

Registration entitles you to product support, full warranty benefits, and notice of product enhancements and upgrades. You MUST complete and return the following to validate your warranty and registration. Thank you again for choosing Cathedral Pipes .

MODEL ______SERIAL No.______

PURCHASE DATE ______SUPPLIER ______

------

Please detach this portion and send it to Cathedral Pipes

MODEL ______SERIAL No. ______

PURCHASE DATE ______SUPPLIER ______

NAME OF OWNER______

NAME OF STUDIO______

ADDRESS:

______

CITY, STATE, ZIP

______

TELEPHONE NUMBER