IF YOUR MAIN INTEREST IS CUTTING CAR FUEL COSTS, THEN GO HERE
The purpose of this web site is to provide you with an introduction to a series of devices which have been shown to have very interesting properties and some are (incorrectly) described as 'perpetual motion' machines.
What's that you say - perpetual motion is impossible? My, you're a difficult one to please. The electrons in the molecules of rock formations have been orbiting steadily for millions of years without stopping - at what point will you agree that they are in perpetual motion?
So, why don't electrons run out of energy and just slow down to a standstill? Quantum Mechanics has shown that the universe is a seething cauldron of energy with particles popping into existence and then dropping out again. Knowing that E = mC2, we can see that a tremendous amount of energy is needed to create any form of matter. Scientists remark that if we could tap even a small part of that energy, then we would have free energy for our lifetime.
The Law of Conservation of Energy is undoubtedly correct when it shows that more energy cannot be taken out of any system than is put into that system. However, that does not mean that we cannot get more energy out of a system than we put into it. A crude example is a solar panel in sunlight. We get electrical power out of the panel but we do not put the sunlight into the panel - the sunlight arrives on its own. This example is simple as we can see the sunlight reaching the solar panel.
If, instead of the solar panel, we had a device which absorbs some of the energy which Quantum Mechanics observes and gives out, say, electrical power, would that be so different? Most people say "yes! - it is impossible!" but this reaction is based on the fact that we cannot see this sea of energy. Should we say that a TV set cannot possibly work because we cannot see a television transmission signal?
Many people have produced devices and ideas for tapping this energy. The energy is often called "Zero-Point Energy" because it is the energy which remains when a system has its temperature lowered to absolute zero. This presentation is introductory information on what has already been achieved in this field: devices which output more power than they require to run. This looks as if they contradict the Law of Conservation of Energy, but they don't, and you can see this when you take the zero-point energy field into account.
The material on this web site describes more than thirty different devices, with diagrams, photographs, explanations, pointers to web sites, etc. As some of the devices need an understanding of electronic circuitry, a simple, step-by-step instruction course in electronics is also provided. This can take someone with no previous knowledge of electronics, to the level where they can read, understand, design and build the type of circuits used with these devices.
This is a very interesting field and the topic is quite absorbing once you get past the "it has to be impossible" attitude. We were once told that it would be impossible to cycle at more than 15 mph as the wind pressure would prevent the cyclist from breathing. Do you want to stay with that type of 'scientific' expert? Have some fun - discover the facts.
There are many, many interesting devices and ideas already on the web. This site does not mention them all by any means. What it does, is take some of what are in my opinion, the most promising and interesting items, group them by category, and attempt to describe them clearly and without too many technical terms. If you are not familiar with electronics, then some items may be difficult to understand. In that case, I suggest that you start with the 'Electronics' section and go through each part in order, moving at whatever speed suits you, before examining the other sections. I hope you enjoy what you read.


Note: When you have finished reading any of the sections shown below, use the 'Back' button of your browser
to return to this page. You will need the latest version of the Adobe 'Acrobat' reader to display these sections.
It can be downloaded free from: Adobe


THE INFORMATION PRESENTED ON THIS WEB SITE IS FOR INFORMATION PURPOSES ONLY. SHOULD YOU DECIDE TO PERFORM EXPERIMENTS OR CONSTRUCT ANY DEVICE, YOU DO SO WHOLLY ON YOUR OWN RESPONSIBILITY -- NEITHER THE COMPANY HOSTING THIS WEB SITE, NOR THE SITE DESIGNER ARE IN ANY WAY RESPONSIBLE FOR YOUR ACTIONS OR ANY RESULTING LOSS OR DAMAGE OF ANY DESCRIPTION, SHOULD ANY OCCUR AS A RESULT OF WHAT YOU DO.

The main information on this web site has been gathered together into a standard book format. You can download the entire set of information, including the patents, using this link Book Release 6.0. The document contains some 1,800 pages and has a file size of 20 Mb which means that it will take some time to download. It is also possible to use a background download from MegaUpload with this Link. Alternatively, you can pick individual chapters as you wish. May I suggest that you store anything you download on your local drive as web sites do not remain in place for ever.
Chapter 1 Magnet Power: Introduction, Contents, Overview, COP, Wang Shum Ho magnet motor, Bedini magnet motor, Ecklin-Brown magnetic generator, the Phi Transformer, Howard Johnson magnet motor, Carousel magnet motor, Robert Tracy magnet motor, Ben Teal electromagnetic motor, Jines magnet motor, Invention Intelligence magnet motor, Stephen Kundel's magnet motor, Charles Flynn's magnet motor and Lines of Magnetic Force. size 638 Kb, 4 Oct 2008 HTML
Chapter 2 Moving Pulsed Systems: The Adams motor, Harold Aspden's modifications of the Adams motor, Teruo Kawai's motor, self-powered 800 watt generator, the Muller motor, the RotoVerter, Phil Wood's energy pick-up, Phil Wood's DC motor RotoVerter modification, the David Kousoulides energy pick-up, thyristor testing circuit and alternator design details from Prof. Kevin Sullivan. size 815 Kb, 5 Sept 2008 HTML
Chapter 3 Motionless Pulsed Systems: Graham Gunderson's Solid-state Electric Generator, Charles Flynn's magnetic power enhancement system, Tom Bearden's Motionless Electromagnetic Generator, Dave Lawton's assymetric MEG, Valeri Ivanov's Motionless Generator, Floyd Sweet's VTA, Dan Davidson's acoustic generator, the Pavel Imris optical amplifier, Michael Ognyanov's self-powered power pack, the Meyer-Mace Isotopic Generator, the Colman/Seddon-Gilliespie generator and Hans Coler's passive device. size 211 Kb, 24 Jun 2008 HTML
Chapter 4 Gravitational Pulsed Systems: Chas Campbell's pulsed flywheel, John Bedini's pulsed flywheel, Johann Bessler's gravity wheel, the Dale Simpson gravity wheel, the Veljko Milkovic pendulum/lever system, the Dale Simpson hinged-plate system and the Murilo Luciano gravity chain. size 244 Kb, 21 Mar 2008 HTML
Chapter 5 Energy-Tapping Pulsed Systems: Frank Prentice's electrical power accumulator, Dave Lawton's cold electricity water-splitter cell, John Bedini's pulsed battery charger, the Tesla Switch, Dave Lawton's cold electricity lightbulb, Bob Boyce's TPU energy tapping circuit, Steven Mark's TPU, comments from Jack Durban on Steven's TPU, a Nikola Tesla patent, the Ed Gray power tube, Radiant Energy waves, Nikola Tesla's experiments, the Alberto Molina-Martinez generator, Alfred Hubbard's device and Floyd Sweet's VTA. size 449 Kb, 30 Apr 2008 HTML
Chapter 6 Battery-Charging Pulsed Systems: John Bedini's pulsed systems, battery information from Ronald Knight, Ron Pugh's battery charger build, a self-charging battery pulser and the Tesla Switch. size 430 Kb, 20 Jun 2008 HTML
Chapter 7 Aerial Systems: Nikola Tesla's system, Thomas Henry Moray's system, Moray King's circuit suggestions, Hermann Plauston's systems and Roy Meyer's device. size 189 Kb, 10 Jun 2008 HTML
Chapter 8 Self-Powered Engines: The energy in air, Bob Teal's compressed air engine, Scott Robertson's thoughts on putting low-pressure air into a tank of high-pressure air, the Leroy Rogers compressed-air vehicle engine adaption, the Vortex Tube, the Eber Van Valkinberg compressed fluids engine, the Clem engine, Vortex analysis by Prof. Evert, the Josef Papp engine, the Robert Britt engine and the Michael Eskeli turbines. size 1.5 Mb, 26 May 2008 HTML
Chapter 9 Passive Systems: Hans Coler's device, Thomas Trawoeger's pyramid, Karel Drbal's pyramid, James Brock's pyramids, Verne Cameron's pyramid transmission technique, the Pancake coil, Peter Grandic's patent, the Joe Cell, Bill Williams' design and recent analytical advances. size 584 Kb, 4 June 2008 HTML
Chapter 10 Vehicle Systems: The HydroStar and HydroGen designs, running an engine on water alone, Hydroxy Boosters, the Smack's Booster design plans, electrolyser design, the Hotsabi Booster construction plans, the 7-cell Isolated Cell booster design, the Series Cell design, Pulse Width Modulation current control, controlling heating, dealing with the oxygen sensor, the Zach West electrolyser design, electrolyser principles, Bob Boyce's high-efficiency electrolyser system, how to wind Bob's toroid, running with high voltage, water-level sensors, water supply systems, connecting to the engine, safety devices, timing details, diesel engines, dealing with 'waste' sparks, measuring gas output rates, operating from the mains, Bob Boyce's experiences, Dave Lawton's replication of Stan Meyer's Water Fuel Cell water-splitter, Dave Lawton's circuits and construction details, pipe-tuning details, Tad Johnson's ultra low-power water splitting, Stan Meyer's water injection system, mpg improvement through cam timing, the Firestorm spark plug, water vapor injection systems, the Ram Implosion Wing, Fuelsavers, high mpg carburettors, Vortex fuel reformers, water as a fuel and the weird nature of water. size 2.0 Mb, 4 Oct 2008 HTML
Chapter 11 Other Devices: Nikola Tesla's power from air system, Dr. Harold Apsden's Electrical Power Generating Apparatus patent, Our Energy Future, Paulo and Alexandra Correa's conversion of Longitudinal Electromagnetic Waves to ordinary electricity, Prof. Constantin Meyl's scalar wave information, Nikola Tesla's MHD device, the effects of the Zero-Point Energy field, John R. R, Searle's self-powered garvitational device, construction details for Dave Lawton's gravity wave detector, the Butch Lafonte motor/generator, the Joseph Newman motor, the differences between Maxwell and Heaviside, Daniel Cook's electrical generator and Michael Eskeli's work-free heater design. size 762 Kb, 15 June 2008 HTML
Chapter 12 Electronics Tutorial: Simple descriptions of Voltage, resistors, capacitors, current flow, multimeters, transistor circuits, sensor systems, relays, diodes, transistor testing circuits, Power Supply Units, AC, DC, rectification, the SCR, the triac, the opto-isolator, LEDs, chokes, transformers, the Schmitt Trigger, solenoids, RF detection, coil impedance, the diode bridge, multivibrators, inverters, truth tables, the 7414 chip, NAND gates, latches, bistables, gating, the 4093 chip, prototype construction, the 4011, the Darlington pair, using a gate as an amplifier, the 555 chip, the 741 chip, op-amps and comparators, the 4022 chip, laying out a circuit, test equipment and how to build it, and 'the weird stuff'. size 475 Kb, 31 Mar 2008 HTML
Chapter 13 Doubtful Devices: Paul Baumann's Thestatika, Michael Faraday's Homopolar Generator (or the N-Machine), the Romag and Mini-Romag, Cold Fusion, Moller's Atomic Hydrogen Generator, Muammer Yildiz's 'Ocean Star' electrical generator, Jesse McQueen's 'Internal Energy-generating Power Source', the 'D18' Nitro Cell, the HydroStar and HydroGen systems, Hydrogen from Aluminium, Francois Cornish's system and Ultrasonic Water-splitting. size 740 Kb, 6 Aug 2008 HTML
Chapter 14 Renewable-Energy Devices: Efficient solid-fuel burners, Stan Meyer's hydroxy gas burner system, the Eugene Frenette heater, the Eugene Perkins heater, the multi-disc heater, the Peter Davey heater, the simple home-build windmill design from Dan Bartmann and Dan Fink, Frank Herbert's high-efficiency windmill, the 'Power Plant for Caravans' from Claude Mead and William Holmes, the easy-build Solar Funnel cooker, water and milk pasteurisation, the Solar Funnel as a Cooler, the Solar Puddle, the 'Easy-Lid Cooker', drinking water systems, solar sills, Elmer Grimes' high-volume drinking water from air, the Chalice Courneya water from air system, Toribio Bellocq's well-pumping system, Richard Dickinson's well-pumping system, Arthur Bentley's well-pumping system, the self-powered Ram Pump and wave-power systems. size 1.2 Mb, 17 Sept 2008 HTML
Chapter 15 The Time Available: The time limits set by coming world events. size 245 Kb, 4 Oct 2008
Index of Devices
Index of People


Report on the Jarboe Mill 'Show and Tell' Event in June 2008
18-19 October 2008 'Show and Tell' Event
Booster construction plans and Suppliers:
Booster 1 The very popular Smack's Booster.
Booster 2 The ultra simple Hotsabi Booster.


Interesting web video links:
Free-Energy Video: Very important presentation introducing the whole subject.
Tom Bearden: Very important interview with Tom Bearden, Part 1.
Tom Bearden: Interview Part 2.
Tom Bearden: Interview Part 3.
Tom Bearden: Interview Part 4.
Tom Bearden: Interview Part 5.
Tom Bearden: Interview Part 6.
Tom Bearden: Interview Part 7.
Tom Bearden: Interview Part 8.
Self-Powered Generator: A small self-powered electrical generator.
Troy Reed System: A powerful electrical generator.
Newman Car: Video showing Joseph Newman's latest car in operation (53 Mb).
Free-Energy Device: Part 1 of a video showing a solid-state over-unity device in operation.
Free-Energy Device: Part 2 of a video showing a solid-state over-unity device in operation.
Free-Energy Device: A video showing Steven Mark's solid-state free-energy device in operation.
Free-Energy Device: A second video showing Steven Mark's solid-state free-energy device in operation.
Free-Energy Device: A third video showing Steven Mark's solid-state free-energy device in operation.
Commercial FE Device: Video of a highly tested series of 140% efficient electrical generators.