Snap n’ Digest / Rev / 04
Page 1 of 2
For Cat # 667 see also:MSDS 00393 TB Phosphate Buffer Bottles and Buffer Packets
Cat #668 see also:MSDS 00393 TB Phosphate Buffer Bottles and Buffer Packets
Reviewed May,2012
Section 1. Identity
Product Name:Snap n’ Digest.
Cat# / Description / SDL Prod ID667 / Snap n' Digest 75ml - 10 bottles/pkg / 00389
668 / Snap n' Digest 150ml - 10 bottles/pkg / 00390
668-997 / Custom Snap n' Digest - 10 bottles/pkg / 00391
Manufacturer/Supplier:Scientific Device Laboratory, 411 Jarvis Avenue, Des Plaines, IL 60018
Phone 847-803-9495
Emergency Information:In case of a chemical emergency, spill, fire, exposure or accident contact Scientific Device Laboratory (847) 803-9495 or CHEMTREC 1-800-424-9300 or 703-527-3887
Section 2. Hazardous Ingredients/Identity Information
Components: The solution contains Sodium hydroxide CAS# 1310-73-2 and N acetyl cysteine CAS# 616-91-1 & deionized water CAS# 7732-18-5
Section 3. Physical/Chemical Characteristics
Boiling Point: 102oC
Specific Gravity: 1.021
Vapor Pressure (mmHg): not known
Vapor Density (AIR=1): N/A
Physical State: liquid
Melting Point: -4oC
Evaporation Rate: vd>1 no information
Solubility in H2O: souble
Appearance: clear
Odor: none
Section 4. Fire and Explosion Hazard Data
Flash point: not flammable
Flammable limits: N/A
LEL/UEL: N/A
Extinguishing medium: CO2
Special Fire Fighting Procedures: no specific instructions
Unusual Fire and Explosion Hazards: none known
Health = 3, Fire = 0, Reactivity = 2
Section 5. Reactivity Data
Stability: stable
Condition to avoid: swallowing
Reagent incompatibility: not known
Hazardous decomposition or By-products: none known
Hazardous polymerization: will not occur
Conditions to avoid: freezing
Section 6. Health Hazard Data
Routes of entry: ingestion: none Inhalation: avoid Skin: wash with water immediately
Ingestion: avoid ingestion
Health Hazards: strong alkali
Carcinogenicity: none
Signs and symptoms of exposure: burning on skin or mucous membranes
Medical conditions aggravated by exposure: none
Emergency First Aid Procedures: avoid skin contact: wash hands or area on body product spilled thoroughly for 15 minutes with soap and water. Respiratory: Wash with water. Wear mask
Section 7. Precautions for Safe Handling and Use
Steps to be taken if material is spilled: clean with large amount of water-
Waste Disposal Method: Whatever cannot be saved for recovery or recycling should be managed in an appropriate and approved waste facility. Although not a listed RCRA hazardous waste, this material may exhibit one or more characteristics of a hazardous waste and require appropriate analysis to determine specific disposal requirements. Processing, use or contamination of this product may change the waste management options. State and local disposal regulations may differ from federal disposal regulations. Dispose of container and unused contents in accordance with federal, state and local requirements.
Precautions to be taken in Handling and Storage: store at room temperature
Other Precautions: none
Section 8. Control Measures
Respiratory Protection: respirator mask
Ventilation: respiratory mask suggested breath fresh air and rinse area with water.
Protective Gloves: chemical resistant gloves
Protective Clothing: Wear impervious protective clothing, including boots, gloves, lab coat, apron or coveralls, as appropriate, to prevent skin contact. Work/Hygiene Practices: good general microbiology techniques
Eye Protection: Use chemical safety goggles and/or a full face shield where splashing is possible. Maintain eye wash fountain and quick-drench facilities in work area.
Section 9. Transport
UN 1824, Sodium Hydroxide Solution, 8, PG III
Scientific Device Laboratory (SDL) will not be responsible for damages of any kind resulting from the use or reliance upon such information. No representations, or warranties either express or implied of merchantability, fitness for a particular purpose or of any other nature are made hereunder with respect to the information set forth herein or to the product to which the information refers. All statements made hereinto are provided in good faith and is believed to be correct as of the date hereof. However SDL makes no representation to the comprehensiveness of such information. It is expected that individuals receiving the information will exercise their independent judgment in determining it appropriate use.
Revision History
CR NUMBER / REVISION0908-001 / 00
0910-001
0511-001 / 01
02
0911-007
0512-005 / 03
04