BLACK & DECKER (U.S.) INC.
TOWSON, MARYLAND, U.S.A. / CONNECTION DIAGRAM / PAGE 1 of 6 /
DOC100242208
REV0.3
This Document Is The Property Of Black & Decker Inc. The Contents Of This Document Are Confidential And Constitute Trade Secrets Proprietary To Black & Decker, Inc. Neither This Document Nor Its Contents Shall Be Disclosed To Any Unauthorized Person, Copied Or Published Without Black & Decker, Inc.'s Prior Written Consent.

GRAPHICS SHOWN MAY REPRESENT VARIOUS MODS.SEE WINDCHILL B.O.M. FOR SPECIFICCOMPONENT USAGE.

NOTES:

  1. PLACE SOLENOIDS AND SECURE WITH STRAPS & SCREWS AS SHOWN. ROUTE WIRES THROUGH TRAPS AS SHOWN TO FRONT OF VACUUM.
    N/A FOR DWV009 NA AND DWV900L MODS.
  1. VERIFY MOTOR VOLTAGE BEFORE INSTALLING MOTOR AND MAKING ANY CONNECTIONS. REFER TO PRINTING ON LABEL AS SHOWN.
  1. ROUTE MOTOR WIRES TO THE SIDE SHOWN AND INSTALL INTO WIRE TRAPS ON TOP OF SOLENOID WIRES. MAKE SURE MOTOR WIRES ARE NOT PINCHED UNDER MOTOR SUPPORT CRADLE AND DO NOT TOUCH SOLENOID PLUNGERS.
  1. ROUTE SOLENOID WIRES WITH MOTOR WIRES ON TOP, LEADING TO FRONT OF VACUUM USING WIRE TRAPS AS SHOWN.

  1. CONNECT SOLENOID AND MOTOR WIRES TO CONTROL MODULE AS SHOWN.
    MAKE GROUND WIRE CONNECTION AS SHOWN.

  1. RUN APPROXIMATELY 290mm OF POWER CORD (ITEM 28) THROUGH STRAIN RELIEFAND SECURE WITH CORD CLAMP (ITEM 29) AND SCREWS (ITEM 8) AS SHOWN.

  1. CONNECT POWER CORD TO TERMINAL BLOCK FROM WIRE HARNESS AS SHOWN AND TIGHTEN SCREWSSECURELY. ATTACHTERMINAL BLOCK TO SEPERATOR PLATE WITH SCREW (ITEM 27) SECURELY.

  1. PUSH TERMINALS 3 AND 6 ONTO TOOL CONTROL SWITCH FULLY.

  1. TERMINALS 8, 9 AND 10 SHOULD EXTEND PAST COVER WHEN ASSEMBLED AS SHOWN. MAKE SURE COVER IS FULLY COMPRESSED AND SECURE. NOTE: N.A. MOD SHOWN.
    FOLLOW IEC STANDARD AC COLOR CONVENTION FOR CONNECTING WIRES TO OUTLET:

LINE – BROWN

NEUTRAL – BLUE
GROUND - GREEN

  1. PUSH TERMINALS 2, 4, 5, AND 7 ONTO MAIN SWITCHFULLY TO HOLD RUBBER SWITCH COVER IN PLACE.
  1. WIRE-UP IS NOW COMPLETE AND SHOULD LOOK AS SHOWN. NOTE N.A. MOD SHOWN.
Supersedes CN:
New Issue CN: CN0250382
Date Released: April 22, 2014 / Title: CONNECTION DIAGRAM
Approved By: ABRAHAM SANCHEZ